IMPORTANT SAFETY INSTRUCTIONS
1 Read all instructions before using this heater.
2 This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes, and curtains at least 3
feet (0.9 m) from the front of the heater and keep them away from
the sides and rear.
3 Extreme caution is necessary when any heater is used by or near
children and whenever the heater is left operating and unattend-
ed.
4 Always unplug heater when not in use.
5 Do not operate any heater with a damaged cord or plug or after
the heater malfunctions, has been dropped or damaged in any
manner. Discard heater, or return to authorized service facility for
examination and/or repair.
6 Do not use outdoors.
7 This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may fall
into a bathtub or other water container.
8 Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from trac area and
where it will not be tripped over.
9 To disconnect heater, turn controls to o, then remove plug
from outlet.
10 Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or re, or
damage the heater.
11 To prevent a possible re, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked.
12 A heater has hot and arcing parts inside. Do not use it in areas
where gasoline, paint, or ammable liquids are used or stored.
Before using your new product, please read these instructions to prevent any damage.
13 Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause re,
electric shock, or injury to persons.
14 Always plug heaters directly into a wall outlet/receptacle.
Never use with an extension cord or re-locatable power tap
(outlet/power strip).
15 Avoid the use of an extension cord because the extension
cord may overheat and cause a risk of re. However, if you have
to use an extension cord, the cord shall be No.16 AWG minimum
size and rated not less than 600 watts.
SAVE THESE INSTRUCTIONS
PACKAGE CONTENTS
• Portable wire heater
• Quick Start Guide
FEATURES
• Wire heating element
• Two power settings: 750 and 1200 Watt
• Silent operation
• Red LED power light
• Double over-heating protection
• Removable rear cover for easy cleaning
• Dust lter
Front
Back
USING YOUR HEATER
1Remove the heater from the package and place on a level
surface, such as a oor or desktop.
2Plug the power cord into a standard 120V outlet. The red
LED turns on.
3Slide the switch to LOW or HI.
CLEANING YOUR HEATER
Important: Your heater has no user-serviceable parts. Do
not disassemble. This will void your warranty. Unplug the
heater before you attempt to clean it.
• Clean your heater with a soft cloth, moistened with
water. Do not use chemical cleaners.
• Vacuum the air intake grill with your vacuum’s brush
attachment every few weeks, for optimal performance.
Frame
LED indicator
Grill
Front stand
Switch
Filter
cover
Back
stand
Switch panel
QUICK SETUP GUIDE
Portable Wire
Heater
NS-HTWFB8 / NS-HTWSL6 / NS-HTWPK6
Flat size (W×H): 11.69 × 8.27 in (297 × 210 mm)
Final folded size: 3.89 × 8.27 in (99 × 210 mm)
NS-HTWFB8_NS-HTWSL6_NS-HTWPK6_17-0320_QSG_V2_EN.ai 1 5/18/2017 10:36:54 AMNS-HTWFB8_NS-HTWSL6_NS-HTWPK6_17-0320_QSG_V2_EN.ai 1 5/18/2017 10:36:54 AM
