Inspire Q Classic Batavia Blue Balance Ball User manual

ASSEMBLY INSTRUCTION
1pc 1pc
E875C BALL CHAIR WITH PUMP
Ball Base Back Post
Support Leg - Back
Ball Back Cushion
Support Leg Caster
1
1pc 4pcs
1pc
1pc
3pcs
C
BD
EG
FH
I K
J L
A
This page lists all the contents included in
the box. Please take the time to identify
the hardware as well as the individual
components to this product. As you
unpack and prepare for assembly, place
the contents on a carpeted or padded
area to protect them from damage.
10pcs
Bolt
Ø1/4"x5/8"
Flat Washer
Ø1/4"x16mm
4pcs
Bolt
∅1/4"x1-3/8"
4pcs
Allen Key
M4
1pc
Spanner
14mm
M
Lock Washer
Ø1/4"x13mm
1pc
1pc
JPump
1pc

Assemble Support Leg (E & F) to the Ball Base (A), using Bolt (H) to fasten by
Allen Key (L).
1
2
2
Assemble Caster (G) to Support Leg (E & F) with Lock Washer (K), then fasten
by Spanner (M).
ASSEMBLY
Do not fully tighten all bolts until assembly is
complete.This will help all parts
to assemble properly.
H
F
E
F
A
G
H4pcs
L
M
K
K
4pcs
F
L
M
E
F
F
F

3
4
3
Assemble Back Post (B) to Ball Base (A) and Suppor Leg - Back (E), using Bolt
(H) & Bolt (I), then fasten by Allen Key (L).
Assemble Back Cushion (D) to Back Post (B), using Bolt (H) & Flat Washer (J),
then fasten by Allen Key (L).
H
H
B
D
I
H
J
H2pcs
L
I 1pc
H4pcs
4pcsJ
L
A
E
L
L
L
B

5
4
Pull out the hole plug, use a Pump (J) to inflate the Ball (C) until it is full, and
then insert the hole plug as below shown. Please make sure the max diameter
of the ball does not exceed 450mm after inflation.
C
A
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant.
Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners.
Hardware may loosen over time. Periodically check that all connections are tight.
6Put Ball (C) onto Ball Base (A) as below shown.
Max 220LBS
plug
plug
air inflation
C
J
Warning: 1.The ball must be used with chair frame together, CAN NOT be
used separately.
2.Maximum total loading weight is not to exceed 220LBS on ball.