INSTYLE FOLIAR Installation manual

FOLIAR INSTALLATION + CARE

INSTYLE.COM.AU
v130115
FOLIAR INSTALLATION
ASSEMBLY INSTRUCTIONS
INSTALLATION
EssentialSource
5 x Foliar leaf tiles
Sold in packs of 5 per colour
Flat packed separately
5 x Foliar base tiles
Sold in packs of 5 per colour
Flat packed separately
Flat-head c/sunk
25mm (1/4 ”) 10g
[ x 4 per tile ]
Power drill Clean hands
Handle with care
during installation
Spirit level
Step 1:
Insert the screw into centre of the base.
Insert the remaining 3 screws.
Step 2:
Fix Foliar leaf into the base and then push
rmly from the centre of each leaf outwards
to snap the Foliar leaf into the base.
Step 3:
Pinch the magnetic ends to create a three-
dimensional effect.
Supplied
Tip:
If you wish for the bottom edge to be horizontal, use a spirit level to
straighten the rst base, then it is as easy as butting the next.
Ensure the following tile is rmly pushed up against the previous for
a tight t prior to screwing into place.
Grouped Scattered
1000m m
1000mm
(39 ")
38
(39 ")
38

INSTYLE.COM.AU
v130115
FOLIAR CARE
Please Note
• Care must be taken when cleaning and consideration to the possible effect of the cleaning regime on the wall surface where the
products are being applied.
• For these reasons it is suggested to spot clean only and that it be carried out by a professional cleaner.
Regular Care
• Protect from direct heat and sunlight.
• To prevent dust build up, lightly dust with a soft cloth or vacuum with a soft brush attachment.
Spot Cleaning
• Professional cleaning is always recommended.
• Always test any cleaning products on an inconspicuous area prior to commencing cleaning.
• Both Leaf and Base may be cleaned with warm soapy water.
• Do not use any product that includes bleach, ammonia or any other solvent based cleaning product on either component.
• Dry away from direct heat and sunlight.