Flash Furniture NAN-TG-2046-BK-GG User manual

Thank you for your purchase!
Standing Desk
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin.
Carefully remove all of the components from the packaging and set aside
for assembly. Assemble on a soft surface to prevent scratching during assembly.
Note: Phillips Screwdriver Required (Not Included)
Caution:
Tighten all components securely before use. Failure to do so may result in
personal injury.DO NOT use any sharp objects to open plastic wrapped
components as damage to product or competitor may result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
Serious or fatal crushing injuries can occur from furniture tipping over.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
46-R-GG

......................................................................................................................................................................................
Thank you for your purchase!
Components
.................................. .................................
................................... ...................................
................................... ...................................
................................... ...................................
................................... ..................................
.................................... ...................................
.................................. .................................
.
.................................... ....................................

......................................................................................................................................................................................
Thank you for your purchase!

......................................................................................................................................................................................
Thank you for your purchase!
Note: Loosen top bolts then
extend the hexagonal rod to
the appropriate length.
(see figure 7),
Hexagonal Rod
Bolts

......................................................................................................................................................................................
Thank you for your purchase!
The drive tube is inserted into the
bottom of the hexagonal bar
Tighten the bolts at both ends

......................................................................................................................................................................................
Thank you for your purchase!
Remove adhesive backing
from part "T" cable clamp and
place on underside of table
behind the button control
panel. Insert cords and lock
clamp
Insert button control
into power adapter
cord on the right then
into power cord on
the left

......................................................................................................................................................................................
Thank you for your purchase!
Height Adjustment Controller Operation

......................................................................................................................................................................................
Thank you for your purchase!