Intellisystem IT610 User manual

Intellisystem Technologies S.r.l. - http://www.intellisystem.it
Quick Installation Guide
IT610
This guide describes the basic functions of
IT610. All detailed information is described
in the user's manual.
Pan/Tilt Network Camera

1
Check package contents
IT610 Power adapter
Antennas (for IT610W and
IT610W-LR models only)
1
Software CD Remote Controller
IT610 Quick Start Guide
Intellisystem Technologies S.r.l. - http://www.intellisystem.it
Home
Auto-Patrol Auto-Pan Center
Stop

2
Physical description
2
Front panel
Back panel
E T H E R N E T
M IC E X T .I/O A V
O U T
12V
1 .5 A
Ethernet 10/100 RJ45 socket
Power cord socket
Microphone
A c tiv it y
P o w er /M IC
Lens and Manual
Focus ring
Status LEDs
A/V out
EXT I/O
External mic
IT610 Quick Start Guide
Intellisystem Technologies S.r.l. - http://www.intellisystem.it

1.If you have external devices such as
sensors and alarms, make connection
from I/O terminal block
3.Finally, connect power cord to a power outlet
3
3
Install your Network Camera in Ethernet network
12V
1.5A
ETHERNET
MIC
EXT.I/O
AV
OUT
P O W E R C O L L IS IO N
L IN K
R E C E IV E
P A R T ITIO N
12345
2.Use Ethernet cable to make connection
from Ethernet port to the hub.
Use Category 5 Cross Cable when Network
Camera is directly connected to PC.
IT610 Quick Start Guide
Intellisystem Technologies S.r.l. - http://www.intellisystem.it

1.Run the Installer from CD-ROM
Assign IP address
4
3.After searching, the main
installer window will pop up.
Click on serial number that
matches the one you just
note from Physical description
2
2.The program will search the
cameras on the same LAN.
4.Click "Link to selected
device" to invoke web
browser to connect to the
camera.
4
Intellisystem Technologies S.r.l. - http://www.intellisystem.it
IT610 Quick Start Guide

5
Intellisystem Technologies S.r.l. - http://www.intellisystem.it
IT610 Quick Start Guide
At the initial access to the“Connection Type”page, the web browser will ask for a new
plug-in installation, the plug in being Network Camera. This plug-in has been
registered for certification and can be used to change the parameters at the client’s
site. The user may click on to install the plug-in. If the web browser does not allow
the user to complete the installation, check the Internet security in order to set on
your web browser to “Ask confirmation for download ActiveX control without
electronic Signature” and so refresh the current web page. If the problem persist
please contact your IT or networking supervisor.
TheInternetExplorerConnectstothe NetworkCamera
5
For detailed information on further conguration, see user's manual on
the CD-ROM.

6
Outdoor Housing Assembling
Components:
Step 1: Get the power wire through the
bracket rst.
6
Step 2: Then through out from the housing
part, meanwhile insert the red and blue
plug to the power socket (P.S. This device
is suitable for AC or DC input, no negative
or positive discriminate)
Step 3: Screw the dome on the xing
brigde.
IT610 Quick Start Guide
Intellisystem Technologies S.r.l. - http://www.intellisystem.it
Step 4: Screw on the two side screws,
and plug in the power of the dome.
Step 5: Finally cover up (plug the antennas
on the bracket, for models IT610W and
IT610W-LR only) and the assembling work
is accomplished.