Intermec EasyCoder 101 User manual

UBI EasyCoder 101 – Installation Instructions
EXTERNAL PAPER ROLL HOLDER
Theoptionalexternalpaperrollholdercanbefittedintheguide
rails either at the top or at the rear of any printer in the UBI
EasyCoder 101 family. The holder is kept firmly affixed by the
locking screw. Thread the web as illustrated below, using the
upper one of the two external paper intakes slots.
The holder is intended to accommodate a paper roll with a
maximum diameter of 180 mm (≈7"). When using dispensing
labelsorself-adhesive strip, keep in mindthatthe standard type
of internal rewind unit cannot accommodate all the backing
paperfrom a full-sized external label roll. Thus,the rewind unit
should be checked regularly and be cleared two or three times
per label roll.
Be careful not to allow the external paper roll be contaminated
byairbornesandorgrit,whichmaycausedamagetothedelicate
printhead.Alwaysremoveorcoverthepaperrollwhencleaning
the premises, especially when dusting or sweeping the floor!
MADE IN SWEDEN
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
TA
PULL/TIREZ
Power
Ready
Error
EasyCoder 101
MADE IN SWEDEN
Type
Art. No.
Ser. No.
115/230 V 2.6/1.3 A 50–60 Hz
TA
PULL/TIREZ
Power
Ready
Error
EasyCoder 101
Locking screw