Intermec EasyCoder PD41 User manual

EasyCoder®PD41/PD42
Internal Rewinder Installation Instructions
These instructions tell you how to install the Internal Rewinder in an
EasyCoder PD41/PD42 printer. Use the internal rewinder to operate the
printer in peel-off mode or batch takeup mode. The kit includes the
following:
Required Tools
To install the interface board in your printer, you need:
• Screwdriver, Phillips
Installing the Internal Rewinder
Before you begin installation, please acknowledge the following important
safety note:
Take precautions against electrostatic discharge, for
example, by wearing grounded wrist straps.
Rewinder module with liner
retention clip
Liner retention guide Four screws (M3x4.5)

To install the internal rewinder
1Open the side door of the printer.
2Remove the two screws that hold the rewinder option cover plate in
place. Keep the screws.
3Remove the liner retention clip from the rewinder unit.
4Attach the rewinder unit to the printer using two of the screws included
in the kit with the two screws that were previously used to hold the cover
plate in place.
Cover plate

Using the Internal Rewinder for Batch Takeup Operation
In batch takeup operation, labels are wound up on the internal rewinder
instead of being peeled off at the tear bar. To be able to use the internal
rewinder for batch takeup, you need to also install the liner retention guide.
To install the liner retention guide
1Remove the thumbscrew to remove the front cover.
2Use the two remaining screws to attach the liner retention guide to the
print mechanism.

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©
2007 Intermec Technologies
Corporation. All rights reserved.
Loading Media in the Printer
For information on how to load the printer with media for peel-off or batch
takeup operation, please refer to the EasyCoder PD41 Printer User’s Guide (P/
N 1-960652-xx) or the EasyCoder PD42 Printer User’s Guide (P/N 934-009-
xxx).
EasyCoder PD41/PD42 Internal Rewinder Installation Instructions
*1-960659-01*
P/N 1-960659-01