Intraphex INTR72SAHD User manual

RV HD Camera and Monitor User Manual & Install Guide
INTR72SAHD
INTR PHEX
electronic S
Your monitor displays a clear, high resolution image of the area
surrounding your vehicle, meaning your maneuvering and vehicle
awareness will be greatlyimproved.
Please ensure you read and understand all aspects of this manual before

3
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
Installation Guide
2
Installation Guide
email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
INTR72SAHD
Introduction
RV HD Camera & Monitor
INTR72SAHD
RV HD Camera & Monitor
Thank you for purchasing your Intraphex RV Camera & Monitor kit. The kit is meant to
assist you in the operation of your vehicle by reducing blind spots while in operations.
Please ensure that you are checking your surroundings to maintain safe operation of your
vehicle. Prior to installing your new system, please fully read this manual carefully before
starting the installation. If you are in need of assistance, our support department can assist
with questions.
Monitor Installation
The monitor will give you a view of your camera. To install your
monitor, first sit in the driver’s seat, and find the ideal position based
on the optimal viewing angle for the driver, it is recommended that
the monitor be mounted on your dashboard.
IMPORTANT: Prior to mounting your monitor, you must first thoroughly
clean the surface area of the dashboard that you will be mounting it
to. It is very important that the surface area is clean of all dust and
fibers, and dry to ensure secure and long-lasting mounting.
Remove the adhesive sticker backing from the monitor base, and adhere the monitor to
the desired dash mounting location. *The monitor can also be mounted using screws for
permanent installation.
Adjust the monitor’s angle by using the Two adjustment knobs located on the back of the
monitor bracket to allow optimum monitor viewing angle.
Main AHD Camera Connection -Labeled CAM IN
Connect the 30 Meter AHD camera cabled connector included in the kit and route
the camera to the rear of the RV or Truck.
NOTE: It may be necessary to remove the trim panels to conceal the excess cable.
INTR PHEX
electronicS
INTR PHEX
electronicS
Installation Wiring Reference
Main Power Connection-Labeled DC 12-24V
RED wire -Connect to the vehicles accessory wire or the circuit that does not have
power when the vehicles key is turned off or when the vehicle is not running,
Suggested location is at the vehicles fuse panel or directly at the vehicle’s ignition
switch.
BLACK wire -Connect to the Vehicles Chassis ground or directly to the vehicle’s
negative battery terminal.
BLUE wire -Connect the BLUE reverse trigger wire to the vehicles reverse wire, this
circuit will have +12 Volts Positive power when the vehicle is set into reverse.
*Suggested connection point is located directly to the reverse light
*Note; The Blue wire is used to trigger the rear camera ON when the vehicle is
shifted into reverse, this wire does not need to be connected if you would like the
rear camera on at all times as you can select the Camera Video 1/2 source to turn
the camera on at all times (Select monitor Main Menu)
Yellow RCA -Secondary Video input -labeled VIDEO IN
The INTRA72SAHD package has a secondary CVBS camera connection input, this
will allow an additional camera to be added to the monitor
* The camera must be a CVBS format
Camera Installation
Mount the AHD camera to the rear center of the vehicle up as high from the
ground as possible, securely mount the v=camera base with the Two
screws provided in the Kit.
Adjust the camera’s mounting angle with the adjustment screws located on
the side of the camera housing.

email - [email protected] (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (Europe)
tel - [phone] (sales) - [phone] (technical)
15500 Lightwave Drive, Suite 202, Clearwater, Florida 33760
Woolmer Way, Bordon, Hampshire, United Kingdom
USER GUIDE
AHD DISPLAY FEATURES
AHD CAMERA FEATURES
7 “ LED AHD DISPLAY
16.9 DISPLAY FORMAT
1X AHD VIDEO INPUT AND 1 X CBVS VIDEO INPUT
AUTO VIDEO SIGNAL DETECTION-WHEN IN REVERSE
PAL/NTSC AUTO SWITCH
350:1 CONTRAST RATIO
RESOLUTION 10249(H) 06009 (V)
SENSITIVE SCREEN 1280 (H) X720 (V)
SYSTEM-PAL
WORKING VOLTAGE 12 V -24 V DC
ANGLE 120 dg
IP68 -WATER RESISTANT
NIGHT VISION ENHANCED
ULTRA SLIM DESIGN