Intratone 04-0106-EN Quick start guide

06-0131-EN: Installation guide
Page 1 / 2 EN-V231-0121-AA
WIRING DIAGRAM
04-0106-EN
12-0110-EN
Wiring
Max 100m from the power supply, using twisted cable Ø 0.5
Max 200m from the power supply, using twisted cable Ø 0.8
12/24 VDC -2AMP
(NOT SUPPLIED)
Right next to the 12-0110-EN
NEVER PLACE THE 17-0102-EN MODULE IN A METAL CASE!
: Alert and door opening are not possible at the same time without adding another 12-0110-EN card.
The LEDs on the 17-0102-EN module indicate the surrounding GPRS network reception quality: the more LEDs you have lit, the better
your reception. For optimal functioning, ensure that you have three LEDs lit.
The presence of keypad beeps indicates that the central unit is correctly connected ( D+/D- bus wired).
The presence of back lighting indicates that the keypad is correctly powered.
DO NOT FORGET TO NOTE THE 17-0102-EN CONTRACT NO. AND THE RELATED ENTRANCE.
You will need this to set up your equipment at www.intratone.com
C
R
T
-
PB
Door Relay
Pushbutton
+
-
D+
D-






17-0102-EN
-
D+
D-
+
Alert
-
D+
D-
+

06-0131-EN: Installation guide
Page 2 / 2 EN-V231-0121-AA
WIRING AND SETTING A DOOR CONNECTED TO A RELAY BOARD
MAGNET LOCK
ELECTRIC LOCK
SWITCH AND SETTINGS
Switch1 Switch 2
Door no.
OFF
OFF
1st
ON
OFF
2nd
OFF
ON
3rd
ON
ON
4th
Switch 3
Button type
-1st
OFF
Normally Open
ON
Normally Closed
The power supplied to the magnet lock must be less than 42 V AC or 60 V DC. If the power supply
voltage exceeds these values, use an intermediate relay (of the correct capacity) to control the
electric lock.
IMPORTANT: The proper operation and long-life are dependent on the fitting of the varistors supplied with the central unit.
1. Varistors must be connected as close as possible to the electric lock or magnet.
2. Free access times should be avoided for doors fitted with electric locks!
3. The varistor supplied is 12 V.
IF YOU INSTALL SEVERAL POWER SUPPLIES, ENSURE THAT YOU CONNECT EACH EARTH (-) TOGETHER.
Door release
time
Door
delay
Switches
1
2
3
The complete pack for managing an isolated door with
1 square proximity reader (04-0106-EN)
1 relay central unit (12-0110-EN)
1 module (17-0102-EN)









Pushbutton
(NO/NC)
C R T
T
Power supply
Magnet lock
Varistor
12-0110-EN









Pushbutton
(NO/NC)
C R T
E.
l
o
c
k
Power supply
Electric lock
Varistor
12-0110-EN
Potentiometer
setting range