1 The USB Wires are located on the Bottom Connector of the TITAN
Wired Back Cover.
2 Use either Wires from PIN 23, 25, 27 and 29 (USB0 wires) or from
PIN 24, 26, 28 and 30 (USB 1 wires) to connect to the 4 PIN female
terminal plug.
3 Strip the USB wires up to 10 mm and crimp them individually to the
AWG 24 crimps provided with the Enhancement Kit.
4 Cut any extra length of exposed copper wire coming out of the crimp.
5 Insert the crimped wires into the respective slots on the female
terminal plug as shown in the image.
6 Tighten the screws on the terminal plug, pull the wires once and
check for loose connection.
7 Connect the female terminal plug to the male terminal plug on the
Enhancement Kit.
Wiring Connections
USB1 Wires
USB0 Wires
TITAN Back Cover
Bottom Connector
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30
23
25
27
29
24
26
28
30
