IOGear GUWIP204 User manual

1
GUWIP204
Part No. M1172-a
Installation
Installation Guide
Wireless 4-Port USB Sharing Station

©2011 IOGEAR®. All Rights Reserved. PKG-M1172-a
IOGEAR, the IOGEAR logo, MiniView, VSE are trademarks or registered trademarks of IOGEAR. Microsoft and Windows
are registered trademarks of Microsoft Corporation. IBM is a registered trademark of International Business Machines, Inc.
Macintosh, G3/G4 and iMac are registered trademarks of Apple Computer, Inc. IOGEAR makes no warranty of any kind with
regards to the information presented in this document. All information furnished here is for informational purposes only and
is subject to change without notice. IOGEAR assumes no responsibility for any inaccuracies or errors that may appear in this
document.

Table of Contents
Package Contents 4
System Requirements 5
Product Overview 6
Hardware Installation 7
Windows Software Installation 10
Mac Software Installation 11
Conguration 14
General Settings 17
WirelessConguration-WEP 18
WirelessConguration-WPA/WPA2 20
AdministratorConguration 21
Maintenance 23
ConnecttoanattachedUSBdevice 24
RequesttoConnect 25
DisconnectingaUSBdevice 27
Auto-ConnectPrinter 28
Network Scanner 31
Firmware Upgrade 35
Troubleshooting 38
Limited Warranty 46
Federal Communications Commission (FCC)
Statement 47
CE Statement 48
Contact 49

4
5
Package Contents
1xWireless4-portUSBSharingStation
1 x Installation Manual
1 x Installation CD
1 x Warranty / Registration card
1 x Power Adapter

4
5
System Requirements
Computer:
CPU of 1.7GHz and above•
Minimum512MBRAM•
Windows XP/Vista /7•
Mac OSX 10.6 and up•
Availablewirelessrouterinhome/ofcenetwork•
Supported Devices:
PrinterorMulti-functionprinterwithUSBconnection*•
External USB hard drive•
USBwebcam*•
USBashdrive•
USB memory card reader•
USB printer•
USB scanner•
*SomeUSBdevicesrequireadirectconnectiontothecomputerforoptimumperformance

6
7
USB connection LED1.
USB port located on the front2.
On/Off Switch3.
Power adapter connector4.
Product Overview
127
3 4 5
Reset button5.
Network port6.
USB ports located on the back7.
Antenna8.
68

6
7
NOTE: Before you connect your USB device to the GUWIP204, please refer to the user manual
and install the driver on your computer rst, for example the driver for your printer. When the
installation is completed, safely disconnect your USB devices from your computer. Disconnect
the power source from USB devices.
Connect your USB device to any one of the USB ports on the USB Sharing Station1.
Hardware Installation
USB device (not included)

8
9
ConnecttheGUWIP204totherouterorswitchwiththeincludedEthernetcable.2.
router (not included)

8
9
ConnectthepoweradaptertotheGUWIP204andturnitonusingtheon/offswitch.TheUSBconnectionLEDwill3.
turn on indicating that unit is correctly connected to the network. Turn on your USB device.

10
Windows Software Installation
Please insert the driver CD into your
Windows based PC. The CD should auto
play and bring up the software installer.
Ifyouhavedisabledtheauto-play
function, please browse the CD and
install the driver program manually.
Follow the instructions of the wizard to
complete the installation process. Once
the installation is complete, click “Finish”
to launch the application.