S1-B AC Triac RF + Push Dimmer
User Manual Ver 1.0.2 Page 4
www.iskydance.com
Use Power Restart
Match:
Switch off the power, then switch on power again,
immediately short press on/off key 3 times on the
remote. The light blinks 3 times means match is
successful.
Delete:
Switch off the power, then switch on power again,
immediately short press on/off key 5 times on the
remote. The light blinks 5 times means all matched
remotes were deleted.
•Color: Change static RGB color.
Short press get 24 kinds static color, long press for continuous static color adjustment.
1
R 100%
9
G 100%
21
R 100%
B 100%
17
B 100%
25(1)
R 100%
5
R 100%
G 100%
13
G 100%
B 100%
•Speed / Saturation:
For dynamic mode, adjust speed.
Short press 10 levels, long press 2s get the default speed.
For static color, adjust saturation, namely change current static color to mixed white slowly. Short
press 11 levels, long press 1-6s for continuous 256 levels adjustment.
•RGBW light:
long press Mode + Speed/Saturation key to adjust W channel brightness simultaneously.
114578 | Sys-Pro SingleColor 1 Zones Surface-mounted touch remote
control with battery
114579 | Sys-Pro SingleColor 2 Zones Surface-mounted touch remote
control with battery
114580 | Sys-Pro dynamic white 1 zones surface-mounted touch
remote control with battery
114581 | Sys-Pro RGB/RGB+W 1 Zones Surface-touch remote control
with battery
Match Remote Control (two match ways)
End user can choose the suitable match/delete ways. Two options are offered for
selection:
Use the controller’s Match key
Match:
Short press match key, immediately press on/off key on the
remote. The LED indicator fast flash a few times
means match is successful.
Delete:
Press and hold match key for 5s to delete all match, The LED
indicator fast flash a few times means all matched remotes
were deleted.
Safety information
1. Read all instructions carefully before you begin this installation.
2. When installing battery, pay attention to the battery positive and negative
polarity. A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery.
3. If no response from the receiver, please re-match the remote.
4. Gently handle remote, beware of falling.
5. For indoor and dry location use only.
