ITC Elio VersiControl 21055 Configuration guide

3030 Corporate Grove Dr. • Hudsonville • MI • 49426
Phone: [phone] • www.itc-us.com • [email protected] • DOC#: 710-00026 Rev C • 09/13/17
VersiControl RGB Control Pad Install Instructions
(Part #’s: 21055)
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6” from any combustible materials.
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
For warranty information please visit www.itc-us.com
1. INSTALL CONTROL PAD: Determine the installation location of your control pad. Note the control module comes with a 7” long cord so
the control pad will need to be located near the module. Drill a 2” hole and insert the control pad. Install the mounting bracket using the
two 3x19mm stainless steel Phillips pan head screws provided. Do not fully torque screws until both have been partially installed.
PARTS / TOOLS NEEDED:
VersiControl RGB
Smart Pad
RGB Lighting
(Varies) Mounting Screws x 2 2” Hole Saw Bit Power Drill
2. CONNECT CONTROL PAD: Insert the connector on the control pad into the
connector on the module.
Controller
1
5
4
3
2
6
V(+)
V(-)
Shield
Signal Line
CAN (+)
CAN (-)
*Mating connector Deutsch DTM06-6S

3030 Corporate Grove Dr. • Hudsonville • MI • 49426
Phone: [phone] • www.itc-us.com • [email protected] • DOC#: 710-00026 Rev C • 09/13/17
3. OPERATION: Below is the keypad overview, for more detailed operational instructions, review your owners manual or visit
http://www.itc-marine.com/product-category/lighting/versicolor-rgb/
Main Power
• Turns system on/off. When powered
back on system returns to previous
state
RGB Indicator LED
• If adjusting colors, this will indicate the
current color selected
• If Quick White button is pressed LED will
turn white and ash
Brightness Adjust Mode
• Enables the ability to adjust the bright-
ness of light output
Left & Right Buttons
• Color Mode: Cycle through RGB colors
• Dim Mode: Increase or decrease
brightness of light
• Fade Mode: Increase or decrease
fade speed
Color Select Mode
• Enables RGB color selection within
currently selected mode
Zone Select Buttons
• Enables selection of zones 1 - 4 to
initiate a color or mode change within
that zone
Effects Mode
• Enables seven color face within the
active zones
Quick White Button
• One press turns all zones white
• Press again to return to previous state
Note: To reset the Bluetooth passcode and clear lock zones, press and release both arrow keys at the same time.