iTOOLco Cannon CM3k User manual

User’s Guide
100 MECO LANE | OAK RIDGE, TN 37830 | 865.670.3713 | ITOOLCO.COM
© 2019 PROPERTY OF ITOOLCO

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 2
BEFORE OPERATION OF THIS TOOL, READ AND
UNDERSTAND ALL OF THE INSTRUCTIONS AND
SAFETY INFORMATION IN THIS MANUAL
Contents
SAFETY FIRST ................................................................................................................................................ 3
SAFETY ALERT SYMBOLS ............................................................................................................................... 3
IMPORTANT SAFETY INFORMATION ............................................................................................................ 4
DESCRIPTION AND IDENTIFICATION ............................................................................................................. 6
SET UP AND OPERATION ............................................................................................................................ 14
LIMITED WARRANTY: ITOOLCO CORDLESS CANNON 3K ............................................................................ 20

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 3
SAFETY FIRST
Safety is essential in the use and maintenance of this tool. This instruction manual and any
markings on the tool provide information for avoiding hazards an unsafe practices related to
the use of this tool. Observe all of the safety information provided.
SAFETY ALERT SYMBOLS
This symbol is used to call your attention to hazards or unsafe practices that could result in
injury or property damage. The three signal words, defined below, indicate the severity of the
hazard. The message after the signal word provides the information for preventing or avoiding
the hazard.
DANGER
Immediate hazards that, if not avoided, WILL result in severe
injury or death.
WARNING
Hazards that, if not avoided, COULD result in severe injury or
death.
CAUTION
Hazards or unsafe practices that, if not avoided, MAY result in
injury or property damage.

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 4
IMPORTANT SAFETY INFORMATION
WARNING
Read and understand all instructions and safety information in
this manual before operating or servicing this tool.
Also read the instruction manual supplied with your drill.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE
INJURY OR DEATH
WARNING – PERSONAL SAFETY HAZARDS
Only qualified persons should use the Cordless Cannon 3K.
Wear eye protection and hard hat when using this tool.
Do not use this tool while tired or under the influence of drugs,
alcohol, or medication.
Keep body parts and loose clothing away from moving parts.
Always follow operating procedures.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE
INJURY OR DEATH.
WARNING – ELECTRICAL SHOCK HAZARDS
Do not expose power tools to rain or wet conditions. Water
entering a power tool can increase the risk of electric shock.
Plug into a (GFCI) ground fault interrupted circuit outlet only.
Use a 20 Amp 120 Volt extension cord no more than 100 feet in
length. Maintain proper care of power cords. Do not use the
cord to carry the tool or pull the plug from an outlet. Replace
damaged cords immediately. Damaged cords can increase the
risk of electrical shock. Do not use this tool near live circuits.
Shut off and lock out power when working near existing
circuits. FAILURE TO OBSERVE THESE WARNINGS CAN RESULT
IN SEVERE INJURY OR DEATH.

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 5
WARNING – ENTANGLEMENT HAZARD
Do not operate this tool while wearing loose-fitting clothing.
Retain long hair.
Keep hands away from pullers capstan. Rope at capstan can
pinch or crush a hand or body part.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE
INJURY OR DEATH.
WARNING – TIPPING HAZARD
Use the same size adapter with conduit. Lock adapter under
conduit nut. Disassemble when not in use. FAILURE TO
OBSERVE THESE WARNINGS CAN RESULT IN SEVERE INJURY OR
DEATH.
WARNING – TOOL USE HAZARDS
Use this tool for manufacturer’s intended purpose only. Use
other than that which is described in this manual can result in
injury or property damage.
Do not use nylon or polypropylene rope. Extreme force can be
stored when rope stretches. Inspect all aspects of the wire pull
to ensure safety.
Inspect all aspects of the wire pull to ensure safety.
Only qualified personnel should use pulling equipment.
Do not use the cable puller as a hoist or winch. The cable puller
cannot lower a load. The load may fall and cause serious injury
or death.
FAILURE TO OBSERVE THESE WARNINGS CAN RESULT IN SEVERE
INJURY OR DEATH.

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 6
DESCRIPTION AND IDENTIFICATION
The iTOOLco Cannon 3K is a 3,000 lb. cordless cable puller intended to pull small to medium wire
through conduit.

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 7

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 8

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 9

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 10

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 11

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 12

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 13

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 14
SET UP AND OPERATION
Step 1. Inspect Puller for damage.
Figure 1.
Figure 1
Step 2. Install adapter plate securing in
place with retainer pins. Figures 2-6.
Figure 2 Figure 3 Figure 4
Figure 5 Figure 6

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 15
Step 3. Install the adapters securing in
place with 18" bungee cord.
Note: 5" and 6" adapters are also
available separately. Figures 7-13.
Figure 7 Figure 8 Figure 9
Figure 10 Figure 11 Figure 12
Figure 13

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 16
Step 4. Install extension
securing in place with retainer
pins. Figures 14-17.
Figure 14 Figure 15 Figure 16
Figure 17
Step 5. Install main roller arm
to puller. Figures 18-24.
Figure 18 Figure 19 Figure 20
Figure 21 Figure 22 Figure 23

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 17
Step 6. Adjust the main roller
and front roller pins for proper
alignment (see Fig. 33). All
pins must be inserted in place
prior to pulling. Figures 25-33.
Seat puller in the conduit.
Adapter should be level or flat
matching the conduit. Figure
33.
Figure 25 Figure 26 Figure 27
Figure 28 Figure 29 Figure 30
Figure 31 Figure 32 Figure 33
Step 7. Extend the puller as
needed for extra wire. Figure
34.
Figure 34

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 18
Step 8. Insert fully charged
battery. Figures 35-36.
Figure 35 Figure 36
Step 9. When ready
begin, thread rope tale over
the rope engagement roller
and pull up on in a steady
continuous motion to start the
pull.
To stop the pull, simply slack
off the rope. This will stop the
pull. Figure 37.
Figure 37
CAUTION: During the pull,
rope must always come in
contact with both front and
main roller. Never bypass a
roller. Figures 38-39.
Figure 38
Figure 39

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 19
Step 10. Press forward/
reverse button to center
position to put in neutral.
Figure 40.
Figure 40

ITOOLCO CANNON 3K USER’S GUIDE
1908CM3KUG
Page | 20
LIMITED WARRANTY: ITOOLCO CORDLESS CANNON 3K
iTOOLco warrants all new Cordless Cannon 3K pullers covered by his agreement, when properly used, to
be free from defects in material and workmanship under normal use and service for which it is intended
for a period of one year from date of delivery by the dealer. Date of delivery shall be the date product is
placed in possession of the user. NORMAL WEAR FROM USE IS NOT PART OF THIS WARRANTY. This
limited warranty is extended to the original user only and is not transferrable to, nor enforceable by any
other person.
iTOOLco will replace free of charge any part(s) of the product found to be defective when such part(s) is
returned to iTOOLco at the address shown below, freight prepaid. If the part(s) if found to be defective,
iTOOLco will refund freight charges paid by you in retuning the defective part(s) and prepay
replacement part(s) freight charges. iTOOLco will not be responsible for more than replacement of any
defective part(s) and standard freight charges (parcel post or UPS ground rate) of any part(s) found to be
defective.
THIS IS THE EXCLUSIVE REMEDY. ITOOLCO SHALL NOT BE RESPONSIBLE OR LIABLE FOR ANY INCIDENTAL
OR CONSEUQNTIAL DAMAGES RESULTING FROM ANY DEFECTS COVERED BY THIS WARRANTY OR ANY
IMPLIED WARRANTY APPLICABLE TO THE PRODUCT INCLUDING, BUT NOT LIMITED TO, PROPERTY
DAMAGE, LOSS OF USE OF PRODUCT, LOSS OF TIME, LOSS OF PROFITS, INCONVENIENCE, COMMERCIAL
LOSS, LABOR COSTS, SERVICE TRIPS, AND MILEAGE.
Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may
not apply to you.
Dealer/Distributor Warranty Claim Procedure
1. All warranty claims must be pre-approved by iTOOLco Warranty Department PRIOR to starting
any warranty work. Warranty work performed without prior approval will not be considered.
2. All claims must be handled through dealer/distributor.
3. Written approval must be received from iTOOLco before return of merchandise. A Return
Authorization is to be returned with the merchandise which is sent back.
4. All parts must be returned to iTOOLco at the address shown below, freight prepaid.
5. The serial number of the product and the date of delivery must accompany the part(s) being
returned.
6. If the part(s) is found to have failed because of a defect in material or workmanship,
replacement will be made on a no-charge basis, and the part(s) returned, freight prepaid.
Standard freight charges (parcel post or UPS ground rate) incurred in returning the part(s) will
be refunded.
7. For reasons of expediency, replacement and/or repair part(s) may be shipped as soon as
possible and billed to the dealer/distributor. When part(s) is returned, if it is covered under
warrant, credit will be issued for the part(s) and freight charges.
8. All parts found to be defective shall be retained by and shall become the property of iTOOLco.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
Corporate Address: iTOOLco
100 Meco Lane
Oak Ridge, TN 37830