IWS LocknCharge iQ Traveller 20 User manual

iQ Traveller 20™
USER INSTRUCTIONS
www.pclocs.com.au www.lockncharge.com

iQ Traveller 20
Congratulaons on your purchase.
Follow these instrucons for easy and fast set-up of your iQ Traveller 20.
PC Locs, LocknCharge and the Padlock device are Trademarks of IWS Global Pty Ltd.
Copyright IWS Global Pty Ltd, May 2014.
iPad and iTunes are trademarks of Apple Inc.
Disclaimer.
This informaon is the intellectual property of IWS Global Pty Ltd and may not be distributed, duplicated
or copied in part or full without the wrien permission. Since the use of this informaon, the equipment
connected and the condions by which any IWS Global product is used is beyond the control of IWS Global,
it is the obligaon of the owner and/or user to determine the correct and safe use of any equipment and
product. To the extent that the law permits, any liability which may be incurred as a result of the use or
future use of a product manufactured or sold by IWS Global is limited to the cost of repairing or replacing the
failed product or component at the discreon of IWS Global either within, or outside of warranty periods,
and does not extend to any loss or damage which may be caused as a consequence of misuse or failure of
the equipment or product or the informaon contained herein. IWS Global shall not in any event be liable for
economic loss of prots, indirect, special, bodily injuries or consequenal damages.

INSTRUCTION MANUAL
Specicaons.
• Exterior Dimensions inches: 24.9(H) x 23.7(W) x 13.1(L)
• Exterior Dimensions mm: 632(H) x 602(W) x 333(L)
• Empty weight (incl. foam): approx 29.8 lbs (13.5kg)
• Fully laden weight: approx 44 lbs (20kg)
• Sealing: IP67 standard
• Corrosion resistant
• Case Construcon: Pelican™ Storm Case™
6 Latches.
Retractable handle.
Locking hole 1.
Air release valve
Locking hole 2.
Wheels behind

iQ Traveller 20
STEP 3 - Charging and syncing.
• Carefully read the User Instrucons for the iQ 16 SCB before aempng to charge or sync your iPad
devices.
• Remove the devices, iQ 16 SCB and cables and place on a stable surface. Aach the power cable, USB
host cable and the 30 Pin USB cables. Place the devices in the desktop stands provided.
• Connect a power cable to the power socket to charge. If syncing, also connect the host cable to the
Macbook. Follow the User Instrucons for the iQ 16 SCB for syncing and charging.
Note: The devices and the iQ 16 SCB can get quite warm during charging and it is strongly recommended
these are not operated inside the foam.
STEP 2 - Storing iPad devices in the
iQ Traveller 20
• Firstly, Insert the devices into foam slots
• The iQ 16 Sync Charge Box and cables can be stored
in the largest slot
• The IEC power cable and USB host cable can be
placed on either sides of the iQ 16 Sync Charge Box
• The iPad stands are then palced over the top so
that they sit at (illustrated in the image below)
STEP 1 - In the box.
Un-pack the iQ Traveller 20 and accessories:
• iQ Traveller 20 case
• iQ 16 Sync Charge Box
• IEC power cable
• USB host cable (USB A to USB B)
• iPad/ Tablet desktop stands
• User instrucons for the iQ Traveller 20
and iQ 16 Sync Charge Box
• Bonus 16x illuminang 30-pin High Speed USB cables

INSTRUCTION MANUAL
STEP 4 - Transportaon.
• A fully laden iQ Traveller 20 with 20 devices and accessories weighs over 20kg and therefore should be
lied only by two or more persons.
• Before moving ensure all four latches are completely closed. The air vent should be kept rmly
closed and only released if the iQ Traveller 20 is subject to large changes in air pressure e.g. on an
aeroplane.
• For mobility the iQ Traveller 20 is ed with a retractable handle and smooth running castors. Simply
li the iQ Traveller 20 onto the castor end and extend the handle, then it can be easily wheeled to the
chosen operang area.
• When opening ensure the iQ Traveller 20 is laying down (label facing upward) so that nothing falls out
when the lid is opened.
Note: Refer to the specicaons diagram for an illustraon.
STEP 5 - Security.
The iQ Traveller 20 can be locked using one or two padlocks secured through the locking hole.
Note: Refer to the specicaons diagram for an illustraon.
STEP 6 - Other features.
• The iQ Traveller 20 has a dust and water resistant seal in between the lid and the case body. If this seal
is damaged replace immediately to connue protecon against dust and water. The seal requires no
maintenance other than cleaning with a damp cloth if it gets dirty – do not use chemical cleaners.
• The castors are ball-bearing type and require no maintenance.
• Three folding handles allow the case to be picked up by more than one person.

iQ Traveller 20
Warranty
PC Locs/LocknCharge warrants the product to be free of defects in design, materials, assembly and crasmanship
for a period of twelve months from the date of purchase to the original retail purchaser. Evidence of original
purchase will be required to obtain warranty service.
In the event that a defect, malfuncon or failure occurs or is discovered during the warranty period,
PC Locs/LocknCharge will repair or replace, at its opon, the products which in the reasonable judgment of PC
Locs/LocknCharge are deemed defecve. All transportaon costs shall be borne by the owner and the risk of
loss shall be upon the party iniang the transportaon.
The warranty does not apply to any product that has been subject to misuse, tampering, neglect, or accident or as
a result of unauthorized alteraons or repairs to the product. The warranty is in lieu of all warranes expressed or
implied, including the implied warranes of merchantability and tness for a parcular purpose which are expressly
excluded or disclaimed. In no event will PC Locs/LocknCharge, their directors, ocers, employees, or agents be
liable for any harm, consequenal, incidental, third party, special or indirect damages whatsoever arising out of the
use or inability to use the products even if PC Locs/LocknCharge has been advised of the possibility of such damages.
PC Locs/LocknCharge obligaon is strictly and exclusively limited to the replacement or repair of any defecve
products. Some states do not allow the exclusion or limitaon of incidental or consequenal damages, so the
above limitaon or exclusion may not apply to you.
Troubleshoong
1. If no lights are illuminated with the iQ 16 Sync Charge Box is switched ON, check that the power cable
is fully inserted into the iQ 16 Sync Charge Box socket and the other end is fully inserted into the mains
power socket and the mains power switch is ON.
2. To check the iQ 16 Sync Charge Box is operang correctly, switch the iQ 16 Sync Charge Box OFF. Remove
all connected USB cables and switch back ON again. Both the Charge light and the Sync light should
inially illuminate but the Sync light will exnguish aer a short delay. This is normal operaon.
3. If the iQ 16 Sync Charge Box is operang normally but the devices cannot be charged, check the USB
cables connecng to the devices are of the correct type and quality and not damaged.
4. If the iQ 16 Sync Charge Box is operang normally but the devices cannot be synchronized, check the
USB cables connecng to the devices are of the correct type and quality and not damaged.
5. Any other issues relang to synchronizaon problems should be referred to your IT department or
provider of synchronizaon soware.

INSTRUCTION MANUAL
Compliances and Approvals

www.pclocs.com.au www.lockncharge.com