Jabra GN9120 Flex User manual

Jabra GN9120 Flex NC Microphone With EHS
How to connect my Jabra GN9120 EHS / GN9125 EHS with
Alcatel IP Touch 4028 EE, 4038 EE, 4068 EE
Prerequisite:
Jabra GN9120 EHS + Jabra Link 14201-20
Jabra GN9125 EHS + Jabra Link 14201-20
In combination with one of the following Avaya phones:
IP 2410
IP 5410
IP 6416D+M/ 6424D+M
Connection:
1. Insert the RJ10 to RJ10 connection cable supplied of the GN912x
into the socket marked with the "phone" on your GN912x base and
the other end into the socket marked with the “phone” symbol on
the EHS adapter.
2. Now connect the end of the RJ45 to RJ45 connection cable (EHS
adapter) marked in “red” to the socket marked with "AUX" on the
EHS adapter as well as with the "AUX" socket on your GN912x base.
3. Now connect the white RJ10 to RJ10 connection cable marked "D" to
the socket marked with "headset/handset" on the EHS adapter as
well as with the “headset” socket on your phone.
4. Connect the dial tone sensor with the EHS adapter and attach this in
the middle on the phone speaker.
23/01/2024 09:38
https://www.jabra.in/supportpages/jabra-gn9120/9120-28-11/faq/b85ae8b4-acbe-
4500-bda6-4c24b352c17d
Page 1 of 3

EHS setup:
The Jabra GN12x must support and be set up on DHSG EHS.
You can check or set it as follows.
1. Place the headset in the base.
2. Then press the PLUS and MINUS buttons simultaneously for 6
seconds until the online display on the headset starts to flash.
3. The base will now display to you the EHS currently installed. The
online light indicates "MSH", the pulsating light indicates "RHL", the
MUTE light "DHSG" and the battery display "AEI".
4. With the PLUS and MINUS buttons, you can now switch into the
different EHS types.
5. To confirm the EHS has successfully installed, the headset
automatically switches back to charge mode after approx. 10
seconds
Base setup:
23/01/2024 09:38
https://www.jabra.in/supportpages/jabra-gn9120/9120-28-11/faq/b85ae8b4-acbe-
4500-bda6-4c24b352c17d
Page 2 of 3

The adjustment controller (small wheel) on the base must be set to "A".
Microphone level setup:
1. Please call someone with the headset.
2. You must now simultaneously press the PLUS and MINUS buttons on
the headset which immediately produces a signal tone.
3. You can now increase the volume with PLUS or decrease the volume
with MINUS.
4. To confirm, after approx. 10 seconds a low signal tone sounds in the
headset in the background. The settings are then saved.
23/01/2024 09:38
https://www.jabra.in/supportpages/jabra-gn9120/9120-28-11/faq/b85ae8b4-acbe-
4500-bda6-4c24b352c17d
Page 3 of 3