AFFIXING SENSOR
Remove protective lm to expose adhesive.1.
Afx sensor to at surface that is in direct line of 2.
sight of your remote control.
TROUBLESHOOTING
Check the batteries in the remote control, if 3.
necessary replace with suitable new batteries.
If you have purchased a new television, you will 4.
need to re-pair the remote control. Refer to PAIRING
THE INFRARED SENSOR on the left.
PAIRING THE INFRARED SENSOR
Press and hold the FUNCTION button until the red 1.
light begins to ash slowly.
Press the button on your remote control that you 2.
want to pair to the infrared sensor (usually the power
button on your on television control is the most
suitable)
The red light will ash quickly and then turn off to 3.
conrm that the pairing is complete.
INSTRUCTIONS FOR USE WITH REMOTE CONTROL
To turn on connected appliances, press the button 1.
on your remote control that has been paired with the
infrared sensor.
The 2. red light will illuminate to indicate that power is
being supplied
To turn off connected appliances press the button 3.
on your remote control that has been paired with the
infrared sensor.
The 4. blue light will illuminate to indicate that the
command has been received.
After 5 seconds, the power will be disconnected 5.
from all connected appliances.
INSTRUCTIONS FOR MANUAL USE
To turn on or off connected appliances, press the 1.
FUNCTION button
The red light will illuminate when power is supplied 2.
to the connected appliances.
FUNCTION
BUTTON
ADHESIVE BACKING
INFRARED
SENSOR
Use your infrared
remote control
to turn power
on / off
