Jasic EVO 2.0 EP-45 User manual

Wilkinson Star Technical
www.jasic.co.uk www.wilkinsonstar.com

Wilkinson Star Technical
www.jasic.co.uk www.wilkinsonstar.com
EP-45 TFT-LCD Screen Fing Instrucons
The following operaon requires sucient professional knowledge on electric aspects and
comprehensive safety knowledge. Make sure the input cable of the machine is disconnected
from the electricity supply and wait for 5 minutes before removing the machine covers.
The below ng instrucons will guide you through the process of removing the ClearVision control
front panel and ng the oponal TFT-LCD control panel for the Jasic Evo EP-45.
Handle screws (A) Top panel (B)
To gain access to the front control panel xing screw, you need to rst remove the handle screws (A)
and then li away the top cover (B) as shown above. This now oers you access to the control panel
retaining screw (C).
Before removing the retaining screw (C), rst detach by hand the ClearVision ribbon cable plug (D) from
socket CN14 and use a crosshead screwdriver to remove the screw securing the earth wire terminal (E).
Once disconnected, you can now proceed in removing the retaining screw (C).
Ribbon cable plug (D) Control panel retaining screw (C)
When slowly pulling the front control panel away, be careful when pulling the ribbon cable and ribbon
plug along with the earth wire through the front plasc access hole (G, next page) ensuring you don’t
damage either these cables or any of the control PCB’s.
4 pin control Socket CN16 (F) Control panel access hole (G) Earthing point (E)

Wilkinson Star Technical
www.jasic.co.uk www.wilkinsonstar.com
EP-45 TFT-LCD Screen Fing Instrucons
The following operaon requires sucient professional knowledge on electric aspects and
comprehensive safety knowledge. Make sure the input cable of the machine is disconnected
from the electricity supply and wait for 5 minutes before removing the machine covers.
You will note that a black rubber grommet (K) is
ed in the access hole (G) to stop dust from into
passing through.
Please ensure you ret the grommet when passing
the new control cable assembly back through (K).
Now that the ClearVision control panel and cables
have been removed, you can now proceed to t
the supplied 4 wire control cable.
From the front, pass the cable assembly through
the access hole (G) and connect the plug to CN16
(H) as shown in the image right ensuring that the
grommet (K) is in place then connect the other end
of the 4 pin cable assembly to the TFT-LCD screen
control socket CN6 (I) as shown below.
Furthermore pass the control panel earth wire through the grommet
and then carefully align the control panel (J) into place ensuring the
cable assembly behind the
control panel is not being
pinched or crushed.
Route and secure in place
the earth wire to the chassis
earth point (E) as shown on
the previous page.
Now re-install back in place the machine lid & handle, as shown on the
previous page (A & B).
Carefully store the old ClearVision
control panel away for safe keeping.
Go to Jasic.co.uk. and navigate to the EP-45 or EP-45SC plasma
product page to download the operang manual which include
the TFT-LCD screen operang instrucons.
Please Note:
It’s recommended during the above installaon procedure an
an-stac strap should be worn.
(J) Locang slots
Control PCB Socket CN6 (I)
Control panel access hole (G) Rubber grommet (K)
TFT-LCD control cable socket CN16 (H)
Control panel access hole (G)
Rubber grommet (K)

Wilkinson Star Technical
www.jasic.co.uk www.wilkinsonstar.com