Jasic EVO 2.0 TR-01 User manual

1

2
Your new product
Thank you for selecng this Jasic EVO 20 product.
This product manual has been designed to ensure that you get the most from your new product.
Please ensure that you are fully conversant with the informaon provided paying parcular aenon
to the safety precauons. The informaon will help protect yourself and others against the potenal
hazards that you may come across.
Please ensure that you carry out daily and periodic maintenance checks to ensure years of reliable and
trouble free operaon.
Please call your Jasic distributor in the unlikely event of a problem occurring.
Please record below the details from your product as these will be required for warranty purposes and
to ensure you get the correct informaon should you require assistance or spare parts.
Date purchased ________________________________________
From where ________________________________________
www.jasic-warranty.co.uk
Disclaimer
Whilst every eort has been made to ensure that the informaon contained within this manual is
complete and accurate, no liability can be accepted for any errors or omissions.
Please Note:
Products are subject to connual development and may be subject to change without noce.
Regularly check our product pages at www.jasic.co.uk for revision updated operang manuals.
No part of this manual may be copied or reproduced by any means without the wrien permission
of Wilkinson Star Limited.

3
PACKAGE CONTENTS AND UNPACKING
Supplied within your new Jasic EVO product package will be the following items.
Use care when unpacking the contents and ensure all items are present and not damaged.
If damage is noted or items are missing, please contact the supplier in the rst instance and before
installing or using the product.
If applicable, record the product model, serial numbers and purchase date in the informaon secon
found on the inside front page of this assembly instrucon manual.
Jasic EVO TR-01 & TR-02 Trolley
(To be used with the Jasic EVO ET-200P ACDC welding and EP-45SC cung machines).
Please Note:
Package contents may very depending on country locaon and package part number purchased

4
ASSEMBLY INFORMATION
For further informaon refer to the operang manual of the product you are ng this trolley too.

5
ASSEMBLY INFORMATION
TIG Filler Wire Holder Fing Instrucons
• Fit the TIG ller wire holder base to locaon A as shown in the below image.
• Fit the TIG ller wire holder to locaon B as shown in the below image.
B
A

6
NOTES
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________

7
NOTES
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________
_____________________________________

8
September 2023 Issue 2