Jaxpety MR11W0214 User manual

Handle
Lifting Lever
Knee Pad
Star Bolt
Rear Wheel Body
Front Wheel
Removable Storage Bag
Brake Cable
Hand Brake Lock
ASSEMBLY INSTRUCTIONS
PULL BACK TO SLOW DOWN PUSH FORWARD TO BRAKE
MAINTENANCE
1. The exterior of this rollator walker should be cleaned periodically with a soft damp
cloth. Do not use abrasive cleaners or caustic chemicals.
2. Check the parts for any looseness, wear, or damage periodically. If any problems are
found, correct them before using them.
3. If haven’t used it for a long time, store it in a cool,dry, and safe place.

1.Insert the rear wheels into the mainframe and make sure the holes are aligned
2.Insert the screw into the hole and secure the “star bolt”
2STEP
REAR WHEELS INSTALLATION
1. 2. 3. 4.
A
Open the mainframe and lock the lever
If you find the frame is unsteady, please tighten the screw
1STEP
ROLLATORS POLE INSTALLATION
1.
4. 5.
3.
1
2
2.
1.
4. 5.
2. 3.
3STEP
LIFTING LEVER INSTALLATION
1.Insert the lifting lever into the mainframe
2.Adjusting the suitable height, then make sure the holes are aligned
3.In
4.Attach the Card buckle to the lifting rod
sert the star bolt into the hole and tighten it
PART LIST
Rear wheel Mainframe Knee pad Bag
Star bolt / Screw Star screw Bag screw
A x 2 Bx 1 x 2
C
Installation tool
1.Insert the knee pad into the tube
2.Adjusting the suitable height , then make sure the holes are aligned
3.Insert the screw into the hole and secure the star bolt
4STEP
KNEE PAD INSTALLATION
1. 2. 3.
A
Make sure the holes are aligned, then insert the screw into the hole and secure the nut with a tool,
5STEP BAG INSTALLATION
1. 2. 3.
C
B