JBL EON 510 User manual

JBL Incorporated, 8500 Balboa Boulevard, P.O. Box 2200, Northridge, California 91329 U.S.A.
JBL EON510/230 REV J
PACKAGE WIRING DIAGRAM
04-13
Technical Manual
JBL EON510/230
SPECIFICATIONS
ACOUSTIC & ELECTRICAL SPECIFICATIONS:
• System Power Rating: 280W continuous, 560W peak
• Frequency Response: 70 Hz – 17 kHz (± 3 dB) (EQ in “Flat”
position
• Frequency Range: 58 Hz – 18.5 kHz (-10 dB)
• LF Power amp: 220W continuous at driver impedance
• HF Power amp: 60W continuous at driver impedance
• Input Gain (input 3): Mic position: -Infinity to +40 dB
Line position: -Infinity to +4 db (+20
dBu Max signal input)
• Input Gain (input 1 & 2): -Infinity to +4 (+20 dBu Max signal
input)
• Input Impedance: 64 K ohms (balanced), 32 K ohms
(unbalanced)
• Boost EQ: LF +3 dB Shelving, Filter @ 150 Hz
HF +2.5 dB Shelving Filter @ 4 kHz
• Low Cut Filter Preset high pass @ 120 Hz
• Crossover Freqeuncy: 1.8 kHz
SYSTEM COMPONENTS:
• Low Frequency 261F, 254 mm (10 in) Differential Drive®
Transducer: integrated woofer with dual 1.5” voice
coils
• DC Resistance: 1.20 ohm ±10%
SYSTEM COMPONENTS: (CONT’D)
• High Frequency 2414H-1, 25.4 mm (1 in) polymer
Transducer: diaphragm, neodymium compression
driver
• DC Resistance: 3.60 ohm ±0.2%
• Input 3 connector: Balanced XLR / /14 inch TRS combo
jack with XLR loop through
• Input 1 & 2 connector: 1/4 inch TRS jack
• Output (Loop/Mix switch): Balanced male XLR,+20 dBu (peak)
o/p level in Mix position
• XLR Pin Assignments: Pin 2 (+), Pin 3 (-), Pin 1 (GND)
AURAL SWEEP TEST SPECIFICATIONS:
A. System Aural Sweep Test: 0.25 V Input, 20 Hz to 2 kHz
Ch1 Input all pots full clockwise
B. L.F. Aural Sweep Test: 5.0V Input, 10 Hz to 300 Hz
C. H.F. Aural Sweep Test: 0.75V Input, 500 Hz to 1.5 kHz
PHYSICAL SPECIFICATIONS:
• Enclosure Dimensions: 490 x 313 x 262 mm D
(19.3 x12.3 x 10.3 in D)
• Shipping Weight: 17 lb (7.7 kg)
WARRANTY INFORMATION:
• Refer to Warranty Statement packed with each product.
Amplifier Assembly
Wire Harness Assembly
364836-001
Driver, High Freq
2414H-1
(363858-001X)
(SEE SCHEMATIC PAGE)
Driver, Low Freq.
261F
(364742-003X)
Cone Repl
C2R261
BLU / BLK
GRN
BLU
GRN / BLK
Warranty 59660
Owners manual
440941-001
(available on web-
site only)
Fillers, (2)
364893-001
Bag
322591-001
19”x16”x42” LG
.003 THKLDPE
CLEAR
Carton
364894-001
Cord, AC, Line
425-00000-00 120V
425-00000-01 230V
+
-
-+

JBL EON510/230
SCHEMATIC ( Wire Harness)
JBL EON510/230
364836-001

COMPONENT EXPLODEDVIEW JBL EON510/230
Screw
813-21300-10
M3.5X 10MM
RND,PH,CLR
ZINC,LCS
(Logo)
Rubber Foot (2)
364870-001
Driver, Low Freq.
261F
(364742-003X)
Cone Repl
C2R261
Dust Dome
31385-07
Screw (4)
804-01110-16
10-32 x 1
FIL,PH,BLK,ZINC,
LCS
Gasket, Woofer
(2)
365350-001
Thumbscrew
364983-001
Side Pocket (2)
364869-001
Screw (6)
814-01100-25
M4 x 25MM
FL,PH,CLR
ZINC, LCS
Amp Board
444970-001
Input Module
358358-001
A/C Inlet PCB
444285-001
Interface PCB
138927-1JBL
Ribbon Cable
141027-1JBL
Amplifier Gasket (2)
364892-001
Screw (10)
813-41300-15
M3 .5X 15MM
PAN,PH,CLR
ZINC,LCS
Wire Harness
364836-001
Heat sink
364881-001
Input Plate
364860-001
Logo Badge
364863-001
Bolt Cover, Badge
364862-001
Insulator Chassis
140493-1JBL
Silipad
140492-1JBL
Cover,Fly Bolt (2)
364805-001
Driver,High Freq.
2414H-1
(363858-001X)
Screw (12)
862-41410-10
6 x 5/8
PAN,PH,HIGHLO,
BLK ZINC,LCS
Screw (8)
365270-001
M4 x 65
Screw (2)
365270-002
M4-33mm
Upper Handle
364868-001
Screw (3)
814-01100-10
M4 x 10MM
FL,PH,CLR,ZINC,LCS
Fly Bolt (3)
364616-001
Nut (3)
838-00800-00
M14 REG,CLR
ZINC,RH
Washer (3)
848-00100-02
M14,REG,CLR ZINC
Enclosure
Assembly EON510
(Not Avilable for
Sale)
Gasket,Enclosure
364835-001
Insert
365433-001
M6 x 12MM
PPB Type
Screw (2)
3654446-001
M3 X 5MM
TREAD CUTTING
Amplifier Shield
365289-001
Screw (4)
814-41300-06
M4 X 6MM
PAN,PHILLIPS
CLEAR ZINC
JBL EON 510/230
Baffle/Grille Assembly
441957-001
EON Letters
365346-001
Grille
Assembly
365357-001
Logo Terminal
Plate
365433-001
Led Board
363395-001
Logo Assembly
364804-001
Please note: grille assembly
not available seperately)

JBL PROFESSIONAL
CUSTOMER SERVICE DEPARTMENT
EON210P, EON 300, EON 500 SERIES REFERENCE CHART
Revision A - October 11, 2012 Page 1 of 1
MODEL LOW HIGH NETWORK AMPLIFIER WIRE LAST
FREQUENCY FREQUENCY ASSEMBLY ASSEMBLY HARNESS YR
MFD
EON210P 443639-001 (328H) 2414H-1 (363858-001X) 444944-001 445356-001 10/5/2012
EON305
M115-8A (124-67001-01X
2414H-1 (363858-001X) 364903-001
EON315 M115-2 (365153-001) 2414H-1 (363858-001X) 365375-001
EON510 261F (364742-003X) 2414H-1 (363858-001X) 364836-001
EON515 261F-1 (363837-001X) 2414H (342423-002X) 364836-001 6/30/2011
EON515XT/230 261F-1 (363837-001X) 2414H (342423-002X) 364836-001
EON518S 268G (364481-001X)
37