Jensen Power760x5D User manual

Power Series Class D Amplifiers
Installation Manual / Quick Start Guide
MODEL NUMBER FUSE SIZE MIN.WIRE GAUGE
2x30A
Power760x5D
Power1100x1D 3x35A
#4
#4
Installation Assistance
For installation assistance, call 1-866-382-5476 during normal business hours,
Monday-Friday, 9AM-5PM EST or visit www.jensenmobile.com at any time.
Supplies and Tools
To install the amplifier, you will need tools,supplies and adapters. It is best to
make sure you haveeverything you need before you start.
Disconnect Battery
Disconnect the negative (-) battery cable before starting the installation. Check
the battery ground (there should be two (2) ground wires coming from the
battery – one going to the starter mounting bolt or engine block and another
going to the vehicle chassis)and make sure the batteryis grounded to the
chassis with at least a #4gauge wire. Also check the alternator connections,
making sure they are tight and free from corrosion, rust or dirt.
Location and Mounting
The amplifier’s compact design allows great flexibility in mounting. Common
mounting locations include under the front passenger seat or in the trunk area.
When selecting a location, remember that amplifiers generate heat.Select a
location on a flat surface away from heat and moisture where air can circulate
around the amplifier.
Recommended Power Wire Size
Power Terminal (+12V) and Ground Terminal (Gnd)
Connect the main power wire to the battery, within 18 inches from the positive
(+) battery post, use an adequate size fuse or circuit breaker capable of
handling the current of the selected power wire. A fuse or circuit breaker must
be installed to prevent a possible electrical fire should the main power wire
short to ground.
POWER INPUT
GND REM +12V
Fuse or Circuit Breaker
Install as close to the
battery as possible.
Battery Terminal
Adapter
Make the ground lead as short as possible, leaving enough length to complete
the installation. To ensure a good ground, scrape away any paint or
undercoating to expose bare metal. Use a "ring" terminal of the proper gauge
and an "outside star washer" (between the chassis and ring terminal) when
making your ground connection.
Drill hole in chassis
Remote Terminal (Turn-On)
Connect the power antenna or amplifier turn-on lead (Switched +12VDC)
from the receiver to the amplifier remote terminal.
POWER INPUT
GND REM +12V
Remote Turn-On (Power Antenna) From Head Unit Receiver
B
A
L
T
SUB-W
MONO
AS/PS
DISP
LOC/DX
12
INT
56
BAND SCAN iEQ
MUTE
MODE
3
RPT
4
SHF
CD2620
DN
UP
i
BA
X
-SS
CHANGER
40 WA TT Sx4
JPTH
CD
AU
-R/RW
i
E
INX
Q
4
AUX
CDRECE IVER
E
L
R
F
AD
E
B
A
S
S
R
E
B
VOL
Drill hole in chassis sheet metal.
Note: Complete amplifier operation manuals are online at
www.jensenmobile.com
All manuals and user guides at all-guides.com
all-guides.com

Speaker Wiring
The Speaker Wiring diagrams illustrate options for connecting speakers.
Observe the proper speaker polarity.
Power1100x1D
One Subwoofer
– – + +
Two Subwoofers
SPEAKER OUTPUT
4 Ohm / 2 Ohm
– – + +
SPEAKER OUTPUT
Power760x5D
Five Speakers
+ CH1 - + CH2 -
+ CH3 - + CH4 -
+ BRIDGED -
+ CH1 - + CH2 -
+ CH3 - + CH4 -
+ BRIDGED -
Power760x5D
Three Speakers
2 Ohm Minimum (Each)
4 Ohm / 2 Ohm Minimum
4 Ohm / 2 Ohm Minimum
4 Ohm Minimum
4 Ohm Minimum
Minimum load is 1 Ohm for any combination of subwoofers
2 Ohm Minimum 2 Ohm Minimum
All manuals and user guides at all-guides.com

Input Wiring
Most trunk/hatchback installations will require a 15-20 foot RCA cable, while
pickup trucks and under-seat mounting will require a 6-12 foot RCA cable.
Connect an RCA cable from your receiver to the RCA input on your amplifier.
Power1100x1D
Power760x5D
POWER
PROTECTION
BASS EQ
012
3
0.5 10
LEFT
RIGHT
LEVEL
60.3
2.5
V
LEVEL
60.3
2.5
V
LEVEL
60.3
2.5
V
FRONT REAR SUB
FLAT HPF FLAT HPF
X-OVER
MODE
5CH 4CH
REMOTE
LPFHPF
HPF
FRONT REAR SUB
3.5 1.5
5
16 Hz 160 16 Hz 160 30 Hz 160
3.5 1.5 3.5 1.5
5
1
30
22 45 22 45 35 80
30 50
150
RIGHT
LEFT
RIGHT
LEFT
POWER
PROTECTION
LEVEL LOW
PASS
80
40300
Hz
BASS
EQ
012
3
dB
SUB
SONIC
20
1040
Hz
60.3
2.5
5
V
3.5 1.5 60 14015 25
1
5
PHASE OUTPUT
INPUT REMOTE
All manuals and user guides at all-guides.com

©2015 Dual Electronics Corp. All rights reserved.
Printed in China
www.jensenmobile.com
Notes:
All manuals and user guides at all-guides.com