Jensen VX4022A User manual

VX4022A
Installation Guide
WARNING! Never install this unit where operation and viewing could interfere with
safe driving conditions.
What’s in the Box
The following items are supplied
with the VX4022A:
•VX4022A Head Unit
•Trim Rings
•Hardware Bag
•Power/Speaker Output Harness
•Remote Control
•External Microphone
•Installation Guide / Warranty
Tools and Supplies
The following tools and supplies
are needed to install the VX4022A:
at-head and Philips
screwdrivers
•Wire cutters and strippers
•Tools to remove existing radio (screw
driver, socket wrench set or other
tools)
•Electrical tape
•Crimping tool
•Volt meter/test light
•Crimp connections
•18 gauge wire for power connections
•16 – 18 gauge speaker wire
•Mounting Sleeve / Side Brackets

1
Optional Equipment
•Steering Wheel Control (SWC) Ready - The VX4022A SWC Interface is compatible with vehicles that utilize a resistive type
SWC circuit. For SWC programming details, please see the operation manual.
•Rear Camera- The VX4022A is Rear Camera ready for vehicles equipped with the option. See wiring diagram for installation
details.
Disconnect the Battery
the ignition and remove the negative (-) battery cable prior to installation.
NOTE: If the VX4022A is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect
the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra
caution during installation to avoid causing a short circuit.
Replacing the Fuse
•When replacing the vehicles Radio fuse always use the proper rated replacement fuse. Using a fuse with an improper rating
re.
ISO-DIN Installation
Using the Cosmetic Trim Ring
NOTE: For proper operation of the CD/DVD player, the chassis must be mounted within 30° of horizontal. Make sure the unit is
mounted within this limitation.
A cosmetic trim ring is supplied with the head unit for installation exibility. This unit will t into most import dashes with little or
no modication to the dash board/cavity. Some US domestic vehicle dashes will accept a Double-DIN chassis, but there is
usually a small gap between the radio and dash piece after installation is complete. In this case, use the trim ring to conceal
any gaps that may be present.

Wiring Diagram
CAUTION! IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully,
or have the installation handled by an experienced technician.
2
Black SiriusXM
-
Black
Black -
RIGHT FRONT +)
RIGHT FRONT SPEAKER (-) RIGHT REAR SPEAKER (+)
RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) BATTERY 12V (+) GROUND (-) ACC / IGNITION (+)
POWER ANT & AMP (+) BRAKE (-) REVERSE (+) LEFT FRONT SPEAKER (-PEAKER (-)
SPEAKER (
)
LEFT FRONT SPEAKER (+)
SPEAKER (-)
SPEAKER (+)SPEAKER (+)
WHITE WHITE/BLACK GRAY GRAY/BLACK PURPLE PURPLE/BLACK GREEN GREEN/BLACK YELLOW BLACK RED ORANGE BLUE PINK GREEN/WHITE
SWC A SWC B
WHITE/PURPLE WHITE/BROWN BROWN/BLACK SWC GND GPS Antenna (VX7022 Only)
HDMI

WWW.ASAELECTRONICS.COM
2602 Marina Drive, Elkhart, IN 46514
© 2015
Printed in China