Jetson LX10 User manual

LX10 Folding Electric Ride-On.
A guide for your ride.
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
MODEL: JLX10-BLK | JLX10-BLU | JLX10-RED
Designed in Brooklyn | Made in China

Remember to be safe and,
most importantly, have fun!

3
Table of Contents
Safety Warnings
Safe Checklist
What's in the Box
Specs & Features
Attaching the Seat
Foot Rest Assembly
Attaching the Rear Fender
Stay Charged
Unfolding the Handlebar
Operating the LX10
Helmet Safety
Riding the LX10
Care and Maintenance
...............................................................................................................4
.................................................................................................................7
.............................................................................................................8
.............................................................................................................11
...........................................................................................................12
..........................................................................................................15
..................................................................................................16
..................................................................................................................18
...................................................................................................19
..........................................................................................................21
................................................................................................................22
...............................................................................................................23
.....................................................................................................24

4
Safety Warnings
• Before use, please read the user manual and safety warnings carefully, and make sure you understand and accept all the safety
instructions. The user will be responsible for any loss or damage caused by improper use.
• Before each cycle of operation, the operator shall perform the preoperation checks speciied by the manufacturer: That all guards and
pads originally supplied by the manufacturer are in proper place and in serviceable condition; That the braking system is functioning
properly; That any and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable
condition; That tires are in good condition, inlated properly, and have suicient tread remaining; The area that the product is to be
operated should be safe and suitable for safe operation.
• Components shall be maintained and repaired in accordance with the manufacturer’s speciications and using only the manufacturer’s
authorized replacement parts with installation performed by dealers or other skilled persons.
• Warning against recharging non-rechargeable batteries.
• Don’t allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts, wheels, or drive train, while the
motor is running.
• This product should not be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction (IEC 60335-1/A2:2006).
• Unsupervised children should not play with the product (IEC 60335-1/A2:2006).
• Adult supervision is required.
• The rider should not exceed 260 lb.
• Units shall not be operated to perform racing, stunt riding, or other maneuvers, which may cause loss of control, or may cause
uncontrolled operator/passenger actions or reactions.
• Never use near motor vehicles.
• Avoid sharp bumps, drainage grates, and sudden surface changes. Scooter may suddenly stop.
• Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility.
• Avoid riding around lammable gas, steam, liquid, or dust that could cause ire.
• Operators shall adhere to all of the manufacturer’s recommendations and instructions, as well as comply with all laws and ordinances:
Units without headlights shall be operated only with adequate daylight conditions of visibility, and; Owners shall be encouraged to highlight
(for conspicuity) using lighting, relectors, and for low-riding units, signal lags on lexible poles.
• Persons with the following conditions shall be cautioned not to operate: Those with heart conditions; Pregnant women; Persons with head,
back, or neck ailments, or prior surgeries to those areas of the body; and persons with any mental or physical conditions that may make
them susceptible to injury or impair their physical dexterity or mental capabilities to recognize, understand, and perform all of the safety
instructions and to be able to assume the hazards inherent in unit use.
• Do not ride at night.
• Do not ride after drinking or taking prescription medication.
• Do not carry items when riding.
• Never operate the product barefooted.
• Always wear shoes and keep shoelaces tied.
• Make sure your feet are always placed securely on the deck.
• Operators always shall use appropriate protective clothing, including but not limited to a helmet, with appropriate certiication, and any
other equipment recommended by the manufacturer: Always wear protective equipment such as helmet, knee pads, and elbow pads.
• Always give way to pedestrians.
• Be alert to things in front and far away from you.
• Do not allow distractions when riding, such as answering the phone or engaging in any other activities.
• The product cannot be ridden by more than one person.
• When you ride the product along with other riders, always keep a safe distance to avoid a collision.
• When turning, be sure to maintain your balance.
• Riding with improperly adjusted brakes is dangerous and can result in serious injury or death.
• The brake may become hot while operating, do not touch the brake with your bare skin.

5
• Applying brakes too hard or too suddenly can lock up a wheel, which could cause you to lose control and fall. Sudden or excessive
application of the brake may result in injury or death.
• If the brake loosens, please adjust with the hexagon wrench, or please contact Jetson Customer Care.
• Replace worn or broken parts immediately.
• Check whether all safety labels are in place and understood before riding.
• The owner shall allow the use and operation of the unit after a demonstration that such operators can understand and operate all
components of the unit before use.
• Do not ride without proper training. Do not ride at high speeds, on uneven terrain, or on slopes. Do not perform stunts or
turn abruptly.
• Recommended for indoor use.
• Prolonged exposure to UV rays, rain and the elements may damage the enclosure materials, store indoors when not in use.
• Do not use this product if the flexible power cord or output cable is frayed, has broken insulation, or any other signs of damage.
California Proposition 65
WARNING:
This product can expose you to a chemical such as Cadmium that is known to the state of California to cause cancer or birth
defects or other reproductive harm. For more information go to www.p65warnings.ca.gov/product
MODIFICATIONS
Do not attempt to disassemble, modify, repair, or replace the unit or any components of the unit without instruction from Jetson Customer
Care. This will void any warranty, and can lead to malfunctions which may cause injury.
ADDITIONAL OPERATION CAUTIONS
Do not lift the product o the ground while it is on and the wheels are in motion. This can result in freely spinning wheels, which may cause
injury to yourself or others nearby. Do not jump on or o the product, and do not jump while using it. Always keep your feet firmly planted
on the foot rest while in operation. Always check the battery charge before using.
MAINTENANCE CAUTIONS
For all maintenance repairs and needs beyond the capability of the consumer which may include but not limited to such as proper
maintenance of brakes, control cables, bearing adjustments, wheel adjustments, lubrication, reflectors, tires and handlebar and seat
adjustments, please contact Jetson Customer Care for assistance at:
support.ridejetson.com
US & Canada 1-[phone]
Hours of Operation: 7 days a week 10am-6pm EST

6
NOTICE OF COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation. Warning: Changes or modiications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
DISPOSAL OF USED BATTERY
Battery may contain hazardous substances which could endanger the environment and human health. This symbol marked on
the battery and/ or packaging indicates that used battery shall not be treated as municipal waste. Batteries should be disposed of
at an appropriate collection point for recycling. By ensuring the used batteries are disposed of correctly, you will help preventing potential
negative consequences for the environment and human health. The recycling of materials will help to conserve natural resources. For more
information about recycling of used batteries, please contact your local municipality waste disposal service.
LIMITED LIFETIME WARRANTY
Limited Life Time Warranty only applies to the Frame & Fork for manufacture defects. Contact Jetson Customer Care for detailed
information via support.ridejetson.com
Limited Lifetime Warranty does NOT cover:
•Normal wear and tear
•Improper assembly
•Corrosion
•Improper maintenance
•Installation of components, parts, or accessories not originally intended for or compatible with the bicycle as sold
•Damage or failure due to accident, misuse, abuse, or neglect
•Labor charges for part replacement or changeover
•Non-proprietary products (any other original part or component) covered by the original manufacturer’s warranty
• Any accessories, brakes, tires

7
Safety Checklist
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR ELECTRIC SHOCK.
IMPORTANT SAFETY INSTRUCTIONS
A READ ALL THE INSTRUCTIONS BEFORE USING THE PRODUCT.
B TO REDUCE THE RISK OF INJURY, CLOSE SUPERVISION IS NECESSARY WHEN THE PRODUCT IS USED NEAR CHILDREN.
C DO NOT PUT FINGERS OR HANDS INTO THE PRODUCT. D DO NOT USE THIS PRODUCT IF THE FLEXIBLE POWER CORD
OR OUTPUT CABLE IS FRAYED, HAS BROKEN INSULATION, OR ANY OTHER SIGNS OF DAMAGE.
D THIS EQUIPMENT IS NOT INTENDED TO BE USED AT AMBIENT TEMPERATURES LESS THAN 20°C 68°F OR ABOVE
AMBIENT TEMPERATURES OF 60°C 140°F.
E THE BATTERY IS INTENDED TO BE CHARGED WHEN THE AMBIENT TEMPERATURE IS BETWEEN 0°C 32°F AND
45°C 113°F. NEVER CHARGE THE BATTERY WHEN AMBIENT TEMPERATURES ARE OUTSIDE THIS RANGE. A GENERAL
WARNING SHALL BE PROVIDED AGAINST MODIFYING OR ATTEMPTING TO REPAIR THE EBIKE SYSTEM EXCEPT AS
INDICATED IN THE INSTRUCTIONS FOR USE AND CARE. IT’S ALWAYS IMPORTANT TO DO A FEW, BUT IMPORTANT, SAFETY
CHECKS BEFORE EVERY RIDE.
LET’S GO THROUGH THEM:
BRAKES
CHECK THE BRAKE IS IN GOOD WORKING ORDER. MAKE SURE PEDALS ROTATE BACKWARDS SMOOTHLY AND THAT THE
REAR AXLE IS LUBRICATED.
STEERING
CHECK THAT THE HANDLEBAR AND STEM ARE SECURELY TIGHTENED.
CRANKS AND PEDALS
CHECK THAT THE FOOT RESTS ARE SECURELY TIGHTENED TO THE CRANKS AND THAT THE CRANKS ARE TIGHTENED
TO THE AXLE.
WHEELS AND TIRES
MAKE SURE THAT THE TIRES ARE INFLATED TO WITHIN THEIR MAXIMUM RECOMMENDED TIRE PRESSURE. CHECK TIRES
FOR EXCESSIVE WEAR OR ANY DAMAGE AND THAT THE WHEEL RIMS ARE NOT DAMAGED. CHECK THAT THE WHEEL SPOKES
ARE NOT BROKEN AND THAT THE AXLE NUTS ARE TIGHT.
FRAME AND FORK
CHECK THAT THE FRAME AND FORK ARE NOT IN ANY WAY DAMAGED OR BROKEN.

8
What’s in the Box
1. HANDLEBAR
2. HANDBRAKE
3. STEM QUICK RELEASE
4. HEADLIGHT
5. FRONT FENDER
6. FRONT TIRE
7. KICKSTAND
8. REAR TIRE
HARDWARE / TOOLS INCLUDED:
DOUBLESIDED WRENCH
NUT 1X  PREATTACHED IN REAR FENDER
BOLT 1X  PREATTACHED IN REAR FENDER
*ADULTS MUST ASSIST CHILDREN IN THE INITIAL ADJUSTMENT PROCEDURES OF THE PRODUCT.
9. REAR FENDER
10. REAR LIGHT
11. SEAT CLAMP
12. SEAT
13. FOOT RESTS
14. CHARGING PORT
15. CHARGER
16. CHARGING CABLE
ALLEN KEY

9
PLEASE NOTE: IMAGES MAY NOT REFLECT EXACT APPEARANCE OF ACTUAL PRODUCT.
1
2
3
4
5
6
8
7
9
10
11
12
15 16
13
14

11
Specs & Features
• PRODUCT UNFOLDED DIMS: 38” × 19” × 36”
• PRODUCT FOLDED DIMS: 38” × 9” × 27”
• PRODUCT WEIGHT: 36 LB
• TIRE SIZE: 10”
• BATTERY: 36V 6AH
• CHARGER: 100240V
• CHARGE TIME: 34 HOURS
• MOTOR: 250W
• MAX SPEED: UP TO 15.5 MPH
• BRAKE TYPE: HAND & DISC BRAKE
• WEIGHT LIMIT: 260 LB
• RECOMMENDED AGE: 12+
Correct Frame Size
FOR SAFE AND COMFORTABLE RIDING THERE SHOULD
BE A CLEARANCE OF AT LEAST 13 INCHES BETWEEN
THE CROTCH AND THE TOP TUBE OF THE BICYCLE
FRAME, WHILE THE RIDER STRADDLES THE BICYCLE
WITH BOTH FEET FLAT ON THE GROUND.
WARNING:
FAILURE TO COMPLY WITH THE FOLLOWING INSTRUCTIONS MAY RESULT IN INJURY TO THE CHILD OR OTHERS.
• KEEP SMALL PARTS AWAY FROM CHILDREN DURING ASSEMBLY.
• ACCESSORY MUST BE ASSEMBLED AND REMOVED BY AN ADULT.
• FREQUENTLY INSPECT THE PRODUCT FOR DAMAGE.
WHEEL
SIZE
1-3
inches

12
1. Get Started
1.1 Attaching the Seat
• INSERT SEAT POST INTO SEAT TUBE.
SLIDE SEAT INTO STEM TUBE.

13
SEAT CLAMP
KNOB
• TURN THE KNOB CLOCKWISE TO TIGHTEN SEAT CLAMP. CLOSE THE SEAT CLAMP.

14
• MAKE SURE SEAT CLAMP IS SECURED AND SEAT IS STABLE.

CAUTION: IT’S IMPORTANT TO STOP IF YOU FEEL RESISTANCE
WHEN PUTTING ON THE FOOT RESTS. IT COULD MEAN THE
SPINDLE IS ENTERING THE CRANK ARM AT AN ANGLE.
15
•INSTALL FOOT RESTS TO AXEL,
TURN FOOT RESTS CLOCKWISE
TO TIGHTEN
1.2 Foot Rest Assembly
FOOT REST

16
1.3 Attaching the Rear Fender
•REMOVE BOLT AND NUT WHICH COME
PREATTACHED TO REAR FENDER.
•RUN THE BOLT THROUGH THE FENDER
AND FRAME.
•SECURE USING THE NUT.

17

18
1.4 Stay Charged
CHARGING THE BATTERY
• ONLY USE THE INCLUDED CHARGER
• PLUG THE CHARGER INTO THE WALL BEFORE THE CHARGING PORT
• DON’T TURN ON THE LX10 WHILE IT’S CHARGING
• CHARGE THE BATTERY UNTIL IT IS FULLY CHARGED  UP TO 4 HOURS
• REPLACE THE COVER OVER THE CHARGING PORT WHEN DONE
CHARGING INDICATOR ON THE CHARGER:
- BATTERY IS CHARGING
- CHARGING IS COMPLETE
• CHARGING TEMPERATURE: 0°C 32°F  45°C  113°F
• DISCHARGING TEMPERATURE: 20°C 4°F  60°C  140°F
• STORE TEMPERATURE: 20°C 4°F  45°C  113°F
CHARGING PORT