JETWAY FCT95 Operating and maintenance instructions

Quick Installation Manual
NO. G03-FCMT95-F
Manual Revision: 1.0
Release Date：March 3, 2020

2
I/O Outlets
Front
Rear

3
Dimension and Outlines

4
I. To dissemble the Chassis
1. Locate the screws at the spots marked on this side of the system and unscrew them one by one.
2. Lift the cover up to open the chassis.

5
3. The internal structural view of the system for further intallation.
II. To Install SO-DIMM to the board
1. Locate the SO-DIMM slot on the board.

6
2. Insert the gold-figure side of the compatible SO-DIMM into the slot at a 30 degree.
3. Press down to secure the SO-DIMM to the slot. The eject tabs will lock automatically if installing direction
is correct.

7
III. To Install M.2 SATA Card(2242)
1. Locate the M.2 SATA (2242) slot on the board. Prepare compatible M.2 SATA (2242) card.
2. To install compatible card, please remove the screw in the marked spot at first.

8
3. Insert compatible 2242 card into the slot.
4. Tighten up the screw removed before to the marked spot to secure the card.

9
IV. To Install Wi-Fi Card and M.2 USB(3042) Card
*Note: M.2 PCIe (E key) is for Wi-Fi card; M.2 USB (3042, B key) is for 3G/4G card. Below is a demonstration
of Wi-Fi card installation. Please use the same way to install M.2 USB(3042) card.
1. Locate M.2 PCIe slot on the board.
2. Remove the marked screw and use it to lock compatible card to the slot in later installation.

10
3. Insert the gold-figure side of the compatible card into the slot and press down.
4. Secure the card to the board by tightening up the screw to the marked spot.