JIMDOA JMD-218 User manual

JMD-218

-1 -
ON/OFF
Reverse
Forward Rotation
Increase speed
Speed indicator
Lifting control key
Decrease speed
Speed display
Storage drill bits
Drill bits(6 pcs)
Drill bits cover
Handpiece hole

DC power cord
Silicone pad
Indicator light
1x electric nail drill main control
1x supply power
1 x handpiece
1 x drill bits set
1 x user manual (in English)
1 x handpiece base

1.DO NOT disassemble the handpiece
2.DO NOT drop the handpiece
3.Do NOT work in a humid environment.
4.Operating environment humidity:30-75%
5.Operating environment temperature:10-26℃
6.Turn o ffthe power when changing the bits
7.Make sure the power switch is o ffbefore
plugging in the power cord to avoid an
unexpected injury due to sudden start.
Power : 80W
Input Voltage : AC 100V-240V 50/60Hz
Speed : 0-35000rpm
Single gross weight : 0.8 kg
Output Voltage : 3-24V

4

3.Operation Steps:
1.Connect the power supply, the alternate light is flashing,
indicating that the product is ready to enter the working
state.
2. Plug the handpiece cord into the handpiece jack on the
machine.
3.When you touch the on-off key“ ”, and the machine
enters the standby state.
4. When toughing the lifting control key“ ”,the nail drill bits
will comes out from the bottom,toughing again,the bits
will shrink from above.
5.When touching the forward and reverse “ ” keys, the
machine will enter the working state. R stands for reverse
rotation and F stands for forward rotation. Touch again to
realize R / F conversion.
6.When touching the “ ” key , it is the upshift key 0-35
(RPM*1000), long press can continuously jump to 35
(RPM*1000), or adjust to the desired setting gear.
7.When the “ ”key is touched, it is the downshift key 35-0
（RPM*1000）, long press can continuously jump to 0
（RPM*1000）, or adjust to the desired setting gear.
8.Press the power button again, the machine stops working
at this time, and the alternate light flashes to indicate that
it is in standby mode.
9.Do not use the machine for a long time, please unplug
the power cord.
+
-