JL Audio Stealthbox SB-P-987C/13TW5v2 Operating and maintenance instructions

INSTALLATION GUIDE
for the
SB-P-987C/13TW5v2
SKU# 94555
2006 - 2013 Porsche Cayman (987)
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system.
With proper installation, your new vehicle-specific enclosed subwoofer system
will deliver years of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized
JL Audio dealer. The installation professionals employed by your dealer have the necessary tools
and experience to disassemble and reassemble your vehicle properly. If you prefer to perform your
own installation, please read this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox®be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
Continued on Next Page
SB-P-987C/13TW5v2 INSTR_SKU# 011349
INSTALLATION
DIFFICULTY:
15
OUT
OF
ESTIMATED TIME:
1/2 HOUR
SPECIFICATIONS
Enclosure Type: Sealed
Driver Type: 13T W5v2
Nominal Impedance: 2 ohms
Continuous Power Handling: 600 watts (RMS method)
INCLUDED HARDWARE
(2) Cinching Straps with Buckles

SB-P-987C/13TW5v2 INSTR_SKU# 011349
POWER RECOMMENDATION
JL Audio recommends high quality ampliers such as the JL Audio XD600/1v2. The diagram below shows the recommended crossover settings for the XD600/1v2. For a detailed description of the amplier settings, con-
sult the owner’s manual for the amplier. If another amplier is being used, please reference this illustration and use similar settings on that amplier.
CONNECTIONS
Using quality power, signal, and speaker wire is essential in ensuring the performance of your Stealthbox®. JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your Stealthbox® amplier. Other kits
are available should you be using more than one amplier. Signal wire such as the JL Audio Premium Audio Interconnect Cables should be used to provide signal for both channels of the amplier. JL Audio
recommends using 12AWG speaker wire for subwoofers.
Continued on Next PagePage 2 • JL Audio, Inc., 2016

SB-P-987C/13TW5v2 INSTR_SKU# 011349
Page 3 • JL Audio, Inc., 2016
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will t in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 6-1/2”- Front Doors
Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650,
C3-650, C5-650x, C5-650, & ZR650-CSi
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc.“Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011349 09.20.2016 • Printed in USA • ©2016 JL Audio, Inc.
For more detailed information please visit us online at www.jlaudio.com.
[phone]
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
STEP 3
Connect speaker cable to the terminal cup on the
enclosure, set the Stealthbox® into position, and route the
wire as necessary. Tighten the Straps around the enclosure
as shown.
STEP 2
Locate the tie-down hooks on each side of the trunk, and
slide a Strap through the hooks.
STEP 1
Empty the trunk of the vehicle.
CONGRATULATIONS!
You have completed the installation for this model. Enjoy your new Stealthbox®!