JMPosner JMP-CCM User manual

model number - JMP-CCM
INSTRUCTION MANUAL
For your safety and continued enjoyment of this product, always read the in-
struction book carefully before using.
JM POSNER
Crepe Maker

SAFETY
UNPLUG FROM THE ELECTRICAL OUTLET WHEN NOT IN USE!
Please take note that the unit will still be too hot to handle immediately
after use.
If the power cord is damaged, it must be replaced by a qualied
technician.
MAINTENANCE
The Crepe plate should be cleaned using warm soapy water after
each day’s operation.
For cleaning the cast iron plate, please use warm soapy water while
the plate is still warm. Do not use cold water on a warm plate.
Do not immerse completely in water to clean.
The appliance should not be cleaned with a water jet.
HELP
If the Crepe plate does not work, please check the following:
1. The power supply is correct and the red is light on.
2. The thermostat is correct.
BASIC SPECIFICATION
Model Voltage Power Dimension
JMP-CCM 220-240V/50/60Hz 2700W 400×400×162mm
1

INSTALLATION
Note: Please take off the plastic lm from the unit.
Take out the Crepe plate from the packaging and locate the unit on a
rm level surface.
When this appliance is to be positioned in close proximity to a wall,
EXPLODED DIAGRAM
CAST IRON PLATE
2

ELECTRICAL DIAGRAM
OPERATION
Plug in the unit, ensure the red light is illuminated. Warm up the unit for
appox. 5 minutes before cooking
Turn the thermostat dial to the required temperature setting for
cooking. The green light will turn off once the cooking temperature is
reached. General cooking temperature is between 180°C and 200°C.
When not cooking, Turn off the thermostat and unplug the unit.
partitions, kitchen furniture, etc., it is recommended that they be made
of non-combustible material, if not, they should be clad with a suitable
non-combustible heat-insulating material, and that close attention
should be paid to re prevention regulations.
Once the Crepe Maker has been placed in position, clean the cast
iron plate thoroughly. Warm up the cast iron plate for 10 minutes until
all smoke and/or odour has dissipated. Switch off and unplug the unit,
then use warm soapy water to clean.
Your Crepe Maker is now ready for use.
NEVER USE COLD WATER ON THE HOT PLATE.
3