JohnsonSuisse Life II Instruction sheet

Wall Basin Model JBSL849.1
Shroud Model JBSL852
Installation Guidelines
Life II - Wall Basin with Shroud
1/2
General Dimensions
RECOMMENDED
HEIGHT
~820
FFL
410
190
70
495
465
166

Bathroom Products Australia
2/97 Banksia St.
Botany, NSW, 2019
Tel: [phone]
Fax: [phone]
[email protected]
www.johnsonsuisse.com.au
2/2
INSTALLATION
• Place the basin at the required position.
• Drill 2 holes 9.5mm in the wall (masonry), insert wall plugs and
screw in the Rag bolts securely. Position the basin, and secure
to the wall using the nuts and washers (refer to diagram 3).
If installing into a timber frame, drill a 5mm pilot hole and
thread rag bolt directly into timber.
• Ensure that the waste and water inlets are in place (refer to
diagram 1).
• Position Shroud under the basin in correct position, and mark
the outline of the shroud, and the position of the mounting holes.
• Remove shroud, and at the mounting holes height mark the
wall holes position about 40mm inwards of the shroud outline.
• Mark the line for the top of the basin (recommended to be 800 -
820mm above finished floor level).
• Remove the basin, and mark the anchoring points 65mm
below the required top line, and 205mm around centerline of
basin (refer to diagram 1 and 2).
• Drill 8mm holes, insert wall plugs and secure the mounting
elbows (refer to diagram 4).
• Make all water and waste connections as required.
• Hold shroud in place, secure with screws from sides, and put
plugs over holes.
• Seal around the sides and top of the basin with a suitable
silicone.
V0.2
Required Tools
ŸDrill
ŸSpanners
ŸHammer
ŸScrewdriver
ŸTape Measure
ŸSpirit level
Ø11
65
205
495
Diagram 2
Diagram 3
Diagram 4
Wall
Plug
Plastic washer
Nut
Rag Bolt
Basin
Metal washer
Outline of
Shroud
~40
DETAIL
L Bracket
Screw
Flange Cap
Diagram 1
Basin Top Line
65
205
RECOMMENDED
HEIGHT
~820
500*
550*
90*
* RECOMMENDED WATER INLET/OUTLET LOCATIONS
= =
500*
550*
90*
* RECOMMENDED WATER INLET/OUTLET LOCATIONS
465
495