Joy S13 User manual

Charging stand S13 User manual
Product Introduction
The Charging stand is a wireless charger used combined with Joy Album K13 made by Joy Home,
Inc.
Product Appearance
Suitable devices
Charging your Joy Album digital photo album
Prepare for worry-free wireless charging. The Joy Album comes with a smart dual-surface
charging stand. Connect the charging stand to a power source by using the included power cable.
Then set your album on either side of the charging stand-magnets will hold it in place and it will
begin charging wirelessly.
Product Specification
Product name Charging stand
operating frequency 111-145KHz

Antenna gain 0dbi
Antenna type Internal type, coil antenna
Power supply 100-240VAC, 50-60Hz, 0.7Amax
Notice:
1. Don't steep the product and isolate liquid
2.Break the power il cleanning is needed
3.Keep use temperature between 0-34 ℃
Cleaning and maintenance
Always disconnect the charger from the mains before cleaning. Clean product components with a
soft, dry and lint-free cloth. Do not use chemical cleaners, scouring agents or liquids! Never
immerse the device in water.
The product does not contain any parts which the user can repair. In the event of a defect,
replace the entire assembly. Contact the manufacturer.
Disposal
Do not dispose of the charger and its components in the
residential waste.
Follow the national disposal regulations.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions
(1) This device may not cause harrnful interference
(2) This device must accept any interference received，including interference that may cause
undesired operation
2. This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body
IC STATEMENT
Canadian Compliance
This device complies with Innovation , Science and Economic Development Canada
S licence-exempt RSSs
Operation is subject to the following conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference that may cause
undesired operation.
Conformité à la règlementation canadienne
Le présent appareil est conforme aux CNR Innovation, Sciences et Développement économique
Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
1.l’appareil ne doit pas produire de brouillage;
2.l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre
le fonctionnement.
This apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus
set out in the interfer- ence-causing equipment standard entitled:“Digital Apparatus,”ICES-003
of the Canadian Department of Communications.
Cet appareil numérique respecte les limites bruits radioélectriques applicables aux appareils num
ériques de Classe B prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”,
NMB-003 édictee par le Ministre Canadian des Communications.