JP-Australia Surfair 9'7" x 32 x 4" SE User manual

1
User
Manual

2
WARNING
DO NOT USE THIS PRODUCT UNLESS YOU HAVE READ AND UNDERSTAND THESE WARNINGS
AND INSTRUCTIONS WHICH ARE FOR YOUR SAFETY AND PROTECTION. THIS INFORMATION
MAY BE SUBJECT TO CHANGE AT ANY TIME. PLEASE VISIT OUR WEBSITE AT: www.jp-
australia.com FOR CURRENT UPDATES.
IF YOU ARE BELOW THE AGE OF 18, YOU SHOULD HAVE YOUR PARENT OR GUARDIAN READ
THESE WARNINGS AND INSTRUCTIONS AND SHOULD NOT USE THIS PRODUCT UNLESS YOU
ARE UNDER THE PROPER GUIDANCE AND SUPERVISION OF SUCH A PERSON.
Familiarize yourself with this inatable board before using it on the water in order to ensure safety and to
prevent accidents.
The use of this product exposes the user to many unavoidable and unexpected risks, DANGERS and
HAZARDS . The suppliers of this product are not responsible for any damage to property or any personal
injury caused by any use, misuse, abuse or irresponsible use of this product by the user.
RECOMMENDED SUP/WINDSURF PRACTICE:
Stand Up Paddling and Windsurng are extremely diverse sports with many disciplines and ability levels. As
with all sports there can be certain inherent risks. The following contains key security points to remember
when using your JP-Australia board and/or JP-Australia Accessory. Observe the following safety standards
and safe operating practices whenever using this product:
• SUP and Windsurng can be very dangerous and physically demanding. The user of this product should
understand that participating in both sports may involve serious injury or death.
• Children should always be under adult supervision.
• Seek SUP/Windsurng instruction from a licensed or certied instructor.
• Check your equipment prior to use for signs of wear & failure, these should be repaired or replaced
immediately and before further use.
• Take time to study the conditions including sea state, tides, currents, weather conditions and forecasts
before you decide to go paddling/windsurng. Beware of paddling/windsurng in offshore or strong winds.
Do not paddle in ood conditions. Never use this product in thunderstorms and lightning conditions.
• Be aware of the conditions as they change. Always return to the beach if there is a signicant change in
the conditions i.e. wind increasing and or waves increasing.
• Familiarize yourself with any new location before venturing onto the water. Ask the locals to tell you about
any hazards. Beware of things such as rip currents, underwater obstacles and heavy shore break.
• Watch out for other beach users, especially swimmers and children. Make sure you keep your board and
paddle under control at all times. Never use this product near other boat trafc, or watercrafts.
• Always use appropriate protective gear and wear a personal otation device. Wear the correct protective
clothing for the conditions such as a wetsuit or a UV top. Cold water and cold weather can result in
hypothermia. Always carry identication.
• Wear a helmet when appropriate.

Valve
Bungee
Handle
Mast plug
D-Ring
EVA Pad
Paddle holder
or D-Ring Fin box
Description
9” Fin
10” Fin
+ screw
+ plate
Center n box
Scotty mount
(Adventurair only)
3
• Always use a SUP specic board leash (not supplied with board). Do not use ankle or knee leash if paddling
in rivers! Use a river specic leash system with quick release within the reach of the hand (waist or chest belt).
• Make sure to stay hydrated during paddling. SUP is a physically demanding sport and dehydration can
also occur in cold temperatures.
• Watch when surfacing after falling in. The board maybe closer than rst imagined due to waves, wind, board leash etc.
• Never paddle alone.
• As you learn the sport, work within your limitations and do not exceed them.
• Never use this product in conditions that are beyond your ability (such as, but not limited to, high surf,
riptides, currents or river rapids).
• Do not exceed maximum weight capacity. Regardless of the number of persons on board, the total
weight of persons and equipment must not exceed maximum weight capacity.
• Do not operate the board under the inuence of drugs or alcohol.
• Keep these warnings, cautions and instructions for future reference.
Model Vol. Capacity
Name (L) (kg)
Surfair 9'7" x 32 x 4" SE 175 85
AllroundAir 10'6" x 32" x 5" SE 256 126
AllroundAir 10'6" x 32" x 5" SE WS CF 256 126
AllroundAir 10’6” x 32” x 6” LE 318 155
AllroundAir 10’6” x 32” x 5” LEC 256 126
AllroundAir 11" x 34" x 5" SE 285 140
AllroundAir 11” x 34” x 6” LE 353 173
AllroundAir 11"x 34" x 6" LE WS CF 353 173
CruisAir 11'6" x 30" x 5" SE 252 124
CruisAir 11'6" x 30" x 5" SE WS CF 252 124
CruisAir 11’6” x 30” x 6” LE 311 152
CruisAir 12'6" x 32" x 5" SE 296 144
CruisAir 12’6” x 32” x 6” LE 367 181
SportstAir 12'6" x 28" x 6" SSE 311 152
SportstAir 12'6" x 30" x 6" SSE 336 167
SportstAir 14'0" x 30" x 6" SSE 377 184
RacAir 12'6" x 25" x 6" SSE 277 136
RacAir 14'0" x 25" x 6" SSE 311 152
RivAir 9’6 x 35” x 6” SE 318 155
AdventurAir 12' x 36" x 6" SE WS CF 405 201
MonstAir 18' x 72" x 8" SE 1700 600
Young Gun Air 212 5" LE WS CF 212 103
YoungGun RacAir 10'6" x 25" x 5" LE 207 101
ExplorAir 295 295 143
FunstAir 310 310 151
Mast plug to attach windsurng rig, center n and the center n box
only comes with boards with windsurf option - WindSup. Paddle
holder only comes with AdventurAir, RivAir and MonstAir boards.

4
Instructions to inate your board:
3- Connect the
pump hose to the
valve, insert and
rotate it to the
right
1- Carefully roll out
the board
2- Pull the valve pin
counter-clockwise
and up
5- Turn from
double action
to single action
when it is
difcult to pump
4- Keep
your feet
rmly on
the foot
rests
and start
pumping
6- Pump your
board to 15 psi
(1 bar)
Any use of an air compressor may
result in poor performance or damage
to the board, and automatically avoids
all warranties. If you leave your board
exposed to the hot sun, check the
pressure and deate it slightly. Otherwise
the board may become over inated
and stretch the material. The ambient
temperature affects the tube’s internal
pressure: a variation of 1°C/ 1.8°F
causes a variation of the pressure in the
tube of +/- 4 mBar (0.06psi).
Warning

5
Inserting the ns:
1- Insert the
front part of
the n into the
nbox
2- Push the
n into the
nbox
3- Tighten the
screw
1- Insert the
plate into the
nbox
2- Push the plate
towards the front
edge of the nbox
3 - Insert the pin of the n
into the nbox cavity and
push the n into the nbox
4- Push the n into the nbox
and tighten the screw
9” Fin 10” Fin

6
Deating the board:
1- Push
the valve pin
clockwise and
down
2- After deation,
roll up the board from
the tail part
3- Store the board
into the bag for
protection
6
Whenever you take your board out of the water and deate it,
allow time for it to air out and dry. Neither the skin/hull nor the
inside chambers will suffer from water damage, but stagnant
water could cause mildew and foul odor.
HOW TO REPAIR SMALL PUNCTURES
Make sure that the board is fully deated and lies at.
1. Prepare a round patch no less than 3 inches or 7 centimeters
in diameter.
2. Clean the patch and the area surrounding the leak with
alcohol.
3. To contain excess glue, use masking tape to tape off the area
around the patch.
4. Apply 3 thin, even coats of repair kit adhesive to both the
surface of the board and the patch. Wait 5 minutes between
each coat.
5. After the 3rd coat, wait 10-15 minutes before applying the
patch. Use a hand roller to apply the patch evenly. Pay special
attention to the edges.
6. Wait 24 hours before re-inating.
• Perform all of your repairs in a well-ventilated area.
• Avoid inhaling glue vapors.
• Avoid contact with the skin or the eyes.
• Keep all repair materials (glue, solvents, etc.) away from the
reach of children.
• The repairs on the welds must not be glued. Only the
manufacturer of the board can perform repairs on the welds
themselves.
MAINTENANCE
1. Clean and check the board as well as all the accessories.
Make sure the board is completely dry before putting it away.
Make sure that neither sand nor gravel remains inside the board
or between the hull and the inner chambers: this could result in
abrasion or even punctures while storing the board.
2. When storing your inatable, keep it in a clean and dry place.

7
JP-AUSTRALIA – LIMITED WARRANTY
Every JP-Australia product is subjected to rigid pre-sales quality control tests and is backed by our comprehensive warranty policy
below.
JP-Australia warrants that this product, when it is purchased from an authorized JP-Australia dealer by a retail customer, will be free
from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original retail customer. This
warranty is solely for the benet of the original retail purchaser and may not be assigned.
For customer Limited Warranty claims, proof of purchase from an authorized JP-Australia dealer is required. If the date of purchase
cannot be established, JP-Australia will make a determination based upon on the last production year of the particular model, or on
the condition of the equipment claimed.
If you have any questions about the JP-Australia Limited Warranty or procedures for making claims thereunder, please contact
your local JP-Australia dealer or JP-Australia at www.jp-australia.com. The JP-Australia Warranty Center will determine if a product
is covered under this Limited Warranty. If covered, JP-Australia will, at JP-Australia’s sole option, repair or replace the product in
question.
All returns must be made through JP-Australia authorized dealers. JP-Australia does not accept returns directly from customers.
Any repair or replacement of any product under this Limited Warranty is not available for ordinary wear and tear, including scratches,
punctures, fading and print chipping, or for any damage caused by misuse, abuse, unauthorized modication or repairs, usage
of components other than JP-Australia components, accident, heat, excessive exposure to sunlight, improper handling, storage,
maintenance or care; incorrect setup, use in commercial, rental or teaching environments; any use of the product outside the
recommended conditions as listed on the JP-Australia website: www.jp-australia.com; use off the water; any blow or impact with a
hard or spikey object or any other irresponsible use.
THE FOREGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES OF QUALITY AND PERFORMANCE,
WRITTEN, ORAL OR IMPLIED AND ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, ARE HEREBY DISCLAIMED. IN NO EVENT SHALL JP-AUSTRALIA BE LIABLE FOR
SPECIAL, INDIRECT, INCIDENTAL, CONSEQUENTIAL, STATUTORY OR EXEMPLARY DAMAGES, WHETHER IN CONTRACT, TORT,
NEGLIGENCE, STRICT LIABILITY OR OTHERWISE including, without limitation, loss to property other than this product, loss of use of
said product, or other property or other economic losses. JP-Australia shall not be liable for contribution or indemnication, whatever
the cause.
Some jurisdictions do not allow limitations on how long an implied warranty lasts and/or the exclusion or limitation of incidental or
consequential damages, so the above limitation and exclusion may not apply to particular customers. JP-Australia obligations under
any warranty shall be limited, to the greatest extent allowed by law, as provided in this JP-Australia Limited Warranty. This Limited
Warranty gives you specic legal rights; you may also have other rights, which vary from one jurisdiction to another.

8
Photos: Marko Butrakovic