Judge JEA84 User manual

Instruction
Manual
Blender
with
Glass
Jug
Model No. JEA84
500W
UNPACK YOUR BLENDER CAREFULLY (CUTTER BLADES ARE SHARP!)
AND REMOVE PACKING PIECES, LABELS AND STICKERS BEFORE USE.
Please read this
instruction manual
carefully before use and
save for later reference.

Blender with Glass Jug
Measuring Cup /
Pouring Hole Cover
(SPARE PART CODE: JEA84M)
Lid, with Pouring Hole
(SPARE PART CODE: JEA84L)
Glass Jug
(SPARE PART CODE: JEA84J)
Jug Handle
Jug Base /
Cutter Blade Assembly
(Take Care - Sharp Blades)
Revolving Spigot
Motor Body
Operating Switch
0 = OFF
1 = Low Speed
2 = High Speed
P = Pulse
Mains Lead and Plug
Identifying the parts
of your Judge Blender
For Spare Parts please contact
Judge Customer Services -
for address see Guarantee Section.
• BEFORE FIRST USE: wash the
assembled Jug and Lid in
warm soapy water, rinse and dry.
• Ensure that the appliance
is disconnected from the
electricity supply before
assembly.

Blender with Glass Jug
Assembly
3. Lower the assembled Glass Jug onto the
Motor Body . With the Operating Switch
facing you the Jug Handle should be on the
right hand side.
1. The Lid must be locked on
to the Glass Jug for the
blender to function. Start by
push fitting the Lid with
the Large Tab positioned to
the right of the Jug Handle
. Rotate the Lid clockwise
so that the two Side Tabs
slide over the corresponding
Tabs on the rim of the Glass
Jug and the Large Tab
comes into line with the Jug
Handle .
2. The Measuring Cup pushes
into the Lid Pouring Hole .
Use
• The appliance should be sited on a dry, level and
stable surface, away from direct heat.
1. Make sure the appliance is switched OFF
(Position 0).
2. Add ingredients to be blended to the Jug .
3. Push fit and lock the Lid in place and return
Jug to the Motor Body (see assembly
instructions).
4. Stabilise the appliance by placing one hand on top
of the Lid (with the Measuring Cup / Pouring
Hole Cover fitted)
5. For best results begin blending by rotating the
Operating Switch anti-clockwise (Position P)
in short bursts two or three times, allowing the
ingredient pieces to drop to the bottom of the Jug
between bursts.
6. Food may then be further blended by using the
Operating Switch in Position 1 (Low Speed) or 2
(High Speed).
• The Lid must always be attached to the Jug
for the appliance to operate.
• Ingredients may also be added to the Jug while
the appliance is operating ( Position 1/2) by
removing the Pouring Hole Cover from the Lid .
Removing
processed food
• Before removing food
from the Jug , wait until
the Cutter Blades have
stopped spinning.
1. Disconnect the appliance
from the electricity
supply.
2. Remove the Lid
(Reverse Step 1 of
Assembly Instructions).
3. Pour food from the Jug
, scraping contents
down with a spatula if
necessary.
• To remove foods of a
more solid consistency,
remove the Cutter Blade
Assembly from the
Jug by unscrewing
clockwise (Take Care -
Sharp Blades). Scrape
food from the Jug with a
spatula.
• NOTE: the appliance will not operate until assembled correctly.

Blender with Glass Jug
Self Clean Function
• Once you have emptied the contents, simply add 1L of water and a small
amount of liquid detergent and follow the “Use” & “Removing processed food”
instructions.
Periodic Cleaning
• Unscrew the Cutter Blade Assembly from the Jug by unscrewing clockwise.
• Thoroughly wash the Jug , Lid and Cutter Blade Assembly using warm
soapy water.
• Detachable parts / / / are also dishwasher safe.
• Motor Body is wipe clean only, using a damp, soapy cloth.
Storage
• Reassemble the appliance and store with Lid ajar in a safe place.
• Keep ingredient pieces roughly the
same size when possible, this makes
uniform blending easier. Cubes
approx. 2.5cm / 1” are ideal.
• It is usually best to put liquid
ingredients into the Jug first.
• The appliance can complete a task
in seconds - stop and check the
consistency every few seconds rather
than over blend.
• Most chopping tasks are best
performed by using the pulse control.
• Do not overload the motor with
extra heavy or extra large loads.
If the blender has been overfilled,
disconnect from mains electricity
supply and remove some of the
ingredients before continuing.
• If you run the motor continuously for
3 minutes, wait at least 5 minutes
before running the motor again.
Tips
• Use a plastic spatula to scrape-down
any pieces of food that stick to the
inside of the Jug : Ensure the
machine is disconnected from mains
electricity supply before placing
utensils or fingers into the jug.
• The maximum temperature of liquid
foods that can be processed is 80°C.
It is better to allow soups, broths
etc to cool to a lower temperature if
possible.
• If processing hot liquids the maximum
capacity is reduced to 1L
• At least one cup of liquid must be
added to Ice Cubes before they will
blend properly.
• The Judge Blender is versatile but
it isn’t a replacement for all other
kitchen gadgets: it will not mash
potatoes, whisk egg whites, chop
raw meat, knead or mix stiff doughs
or extract juices from fruit and
vegetables.

Blender with Glass Jug
Cautions
Before Use
• Check that your mains power supply
corresponds to the voltage shown in this manual
(also shown on the rating plate, located under
the Motor Body ).
• Do not connect the Plug into your socket
with wet hands.
• Ensure that the Mains Lead is not near
any hot surface, and is not in a position on
the worktop where it could be ‘snagged’. The
Mains Lead should not hang over the side of the
worktop, where it could accidentally snagged
or pulled by children. There is a cord shortening
facility located under the Motor Body .
• Do not move the appliance around by pulling
the Mains Lead .
• Inspect the Glass Jug to ensure it is free from
chips or cracks - these could cause the Jug to
break during use causing injury.
• Always keep the appliance out of the reach of
children.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or lack
of experience or knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• This appliance is not intended to be operated
by means of an external timer or a separate
remote-control system.
• The appliance should only be used as
instructed: there is potential for injury from
misuse.
• Never mount the Jug Base /
Cutter Blade Assembly onto the Revolving
Spigot without the Jug attached.
• Never leave the appliance unattended while it is
operating.
• The Jug and Lid must be securely locked
in position before operating the machine: do
not attempt to defeat the safety interlock
mechanisms.
• Do not use any other jug or parts other than
those supplied with the appliance.
In Use
• Do not attempt to remove the Jug
or Lid while the machine is
working.
• Do not operate the motor when
the Jug is empty.
After Use
• Ensure the Cutter Blade Assembly
has come to a complete stop
before removing the Lid from
the Jug .
• Always disconnect the electricity
supply before removing the Jug
from the Motor Body , or
approaching any part that moves
in use.
• Do not use fingers to scrape
food away from the Cutter Blade
Assembly . A plastic scraper
may be used, but only when
the electricity supply has been
disconnected.
• Care must be taken handling the
sharp blades when assembling,
emptying the Jug and during
cleaning.
• Unplug the appliance when not
in use.
• Pull the plug (not pull Mains Lead)
to disconnect from mains socket.
• Do not immerse the Motor Body
in water.
Faults and damage
• If the Jug is chipped or cracked
• If the Mains Lead has been
damaged in any way.
• If the Blender appears to be
faulty or damaged in any way
• Do not switch on or attempt to
operate. Please contact Judge
Customer Services, for address see
Guarantee Section. Never attempt
to repair to the appliance
yourself
• Please keep your purchase receipt.

Blender with Glass Jug
• The Judge 2 Year Domestic
Electrical Guarantee covers the
product to be free of defects in
materials and workmanship for
a period of TWO YEARS from the
date of original retail purchase.
• During this period, JUDGE will,
at their option, repair or replace
defective parts of the product, or
replace the product, providing the
Use Care and Safety Advice have
been followed.
• The Guarantee does not cover
damage, defect or failure caused
by or resulting from accidents,
external damage, alteration,
modification, abuse, misuse or
misapplication.
• The Guarantee does not cover
any damage caused by taking
the appliance apart yourself,
or attempting to repair the
appliance yourself.
• THE PRODUCT IS INTENDED
FOR DOMESTIC USE ONLY.
• Please keep your Purchase
Receipt and contact us directly if
you encounter any problems with
your product.
HORWOOD SHALL NOT BE
LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES
RESULTING FROM THE USE OF
THIS PRODUCT (INCLUDING
COLOUR FADING, SCRATCHES OR
ACCUMULATED DIRT) WITHOUT
FOLLOWING THE USE, CARE
& SAFETY INSTRUCTIONS.
Note: Due to the introduction
of improvements from time to
time, the right is reserved to
supply products which differ
slightly from those illustrated and
described in this publication.
Errors and Omissions Excepted.
CUSTOMER SERVICES
Horwood, Avonmouth Way,
Bristol, BS11 9HX, Great Britain
www.horwood.co.uk
[email protected]
Tel: [phone]
Specification
Name Model No. Capacity Rated Voltage Rated Frequency Rated Power
Judge Blender
with Glass Jug
JEA84 1.5L 220 - 240v 50Hz 500W
Judge 2 Year Domestic Electrical Guarantee
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your
used device, please use the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
FOR DOMESTIC USE ONLY