JumpSport Fitness Trampoline User manual

1
1-877-507-1399
www.fitnesstrampoline.com
Use trampoline only with mature, knowledgeable supervision.
WARNING
Fitness Trampoline™ User’s Manual
Arched Leg, Non-Folding Models
Read these materials prior to assembling
and using this rebounder trampoline
Retain address information for future use.
JumpSport, Inc.
1680 Dell Ave.
Campbell, CA 95008 U.S.A.
Retain address information for future use. Covered by one or more of the following US Patents: No.6.840,891, No.D666,266, and
No. D680,609. Other US and International Patents Pending.
Instruction Manual P/N: INS-P-20764-03I
Copyright © 2003-2017, by JumpSport, Inc. All rights reserved.
(Pictures are for illustration purposes only and may not match actual product.)
 WARNING: Users should consult with a physician before beginning any exercise or conditioning pro-
gram.
 If user feels faint or dizzy, immediately stop using the rebounder trampoline.
 Avoid bouncing when tired. Take breaks often.
 Use only in a well lit area by responsible, mature, non-intoxicated persons.
 Never use trampoline on an un-level surface. Only use when dry.
 Keep away from objects which could interfere with safe use. Clear obstructions underneath, above, or around the
rebounder trampoline. Check for adequate vertical clearance (avoid low ceilings, ceiling fans, light fixtures, etc.) and
lateral clearance (avoid furniture, lamps, walls, other trampolines, etc.).
 Inspect before each use. Replace or adjust any loose, worn, defective, or missing parts.
 Do not jump on and off the trampoline. Do not use the trampoline as a springboard to or from other objects. Do not
step on the frame when getting on and off the trampoline.
 Stop bounce by flexing knees as feet come in contact with the trampoline bed. Learn this skill before attempting oth-
er more advanced moves. Control is more important than bounce height.
 For information concerning skill training, contact a qualified fitness trampoline instructor.
 Store and protect trampoline from unauthorized use.
 For additional information, contact us at JumpSport.com or 1-877-507-1399.
It is the responsibility of the purchaser to become familiar with all of the information in this booklet, to convey the warnings to all
users, and to enforce JumpSport’s rules for safe use.
Commercial Use
Only models in our 300 and 500 Series are for commercial use, and are subject to shorter warranty periods (see Warranty section).
DO NOT attempt or allow
somersaults. Landing on the
head or neck can cause
serious injury, paralysis or
death, even when landing in
the middle of the bed.
DO NOT allow more than one
person on the trampoline.
Use by more than one person
at the same time can result in
serious injury.
If you wish to change the
firmness of your rebounder,
turn it upside down. Then pull
cord tighter to different knot,
according to chart. See pic-
ture for firmness settings.
IMPORTANT: Grab cords
with both hands and be sure
to re-position bungee so ten-
sion remains evenly distribut-
ed. Not re-positioning will
cause cord to wear unevenly.
FlexBounce III = 3 knot
cord
How to Adjust
FlexBounce™ Cords
(if applicable)
FlexBounce III Configurations FlexBounce VII Configurations
Softer Soft Setting on all FlexBounce connectors Soft Setting on all FlexBounce connectors
Medium Setting on every other connector Medium Setting on every other connector
Soft / Medium / Medium Settings (repeat pattern)
Medium Setting on every connector Medium Setting on every connector
Firm Setting on every other connector
Medium / Firm / Firm Settings (repeat pattern)
Firmer Firm Setting on every connector
Soft Setting
(factory setting)
Medium
Setting
Firm
Setting
FlexBounce
connector
FlexBounce VII
shown here

2
IMPORTANT: Be sure leg caps are installed securely over bottom of legs, as shown above.
Leg socket
** Installing Leg Pieces **
Leg cap
(may not be pre-
installed)
Leg
LEG-A-20159-02
Notch in leg socket
WARNING: Periodically check all leg
screws and retighten if necessary. All leg
screws should be tight prior to using the
rebounder trampoline.
6mm Allen wrench
6mm Hex drill bit
(not shown)
Note: Keep Allen wrench to remove
or re-tighten legs, as needed.
Leg screw
SCR-P-20456-01
1) With trampoline upside-down, fit leg sockets over stud on trampoline frame. Notch in leg socket lines up with pin on
stud.
2) Securely tighten the leg to the frame by turning the Leg screw clockwise. The supplied 6mm Allen wrench can also
be used by inserting the short end of the wrench into the hole of the leg screw to tighten securely.
If you are going to install an exercise handle, turn to next page for installation. When all legs are installed, turn your
rebounder over.
The JumpSport Fitness
Trampoline is now ready for use!
IMPORTANT: Bolts may offer
resistance when tightening. No
threads of the bolt should be
exposed when bolt is properly
installed. Use leverage with the
provided 6mm Allen wrench or
use a power drill with a suitable
6mm bit (not supplied) to ensure
safe and proper installation.

3
** Installing Exercise Handle Bar **
1) The 2 handle legs will be installed in place of the normal legs at the 2 locations shown above. Turn trampoline upside-down, fit leg
socket over stud on trampoline frame, and tighten bolts using a 6mm Allen wrench. Be sure that a hinge is between the side handles.
WARNING: If you have handle
legs attached, do NOT attempt to
use the rebounder without the rest
of the handle pieces properly
installed first.
IMPORTANT: A hinge must be between the handlebar assembly.
CAUTION
Avoid Injury.
Exercise handle bar (when
attached to the rebounder) is
not designed to support your
entire weight. It is to aid
with balance and provide
exercise versatility.
2) Connect side handles to top handle, and secure with small
thumb screws to create a “top assembly”.
3) Lower top assembly into handle legs. You may have to
rotate entire top assembly 180 degrees for holes to line up.
Adjust height as necessary, before securing with large thumb
screws.
Your exercise handle bar
is now installed!
To remove the handle, follow the installation
instructions in reverse order.
Small thumb screws
SCR-P-11706A
Left side handle
HAN-P-20170-00
Large thumb screws
SCR-P-11707A
Top handle
HAN-A-20164-02
Right side handle
HAN-P-20169-00
Handle Leg
LEG-A-20324-02

4
Limited Warranty
What is covered by this warranty? This warranty covers any defects in materials or workmanship on all of the compo-
nents of a new JumpSport Fitness Trampoline system, and is extended exclusively to the original retail purchaser.
How long does this coverage last? Warranty coverage for each component of a new JumpSport® Fitness Trampoline
begins from the original date of purchase and lasts as follows
What will JumpSport do? If you return the defective part to JumpSport, as instructed below, JumpSport will either repair
or replace such part, at JumpSport’s discretion, and return it to you.
What is not covered by this warranty? This warranty covers new products purchased as a complete system; it does not
cover replacement parts. This warranty also does not cover expenses of on-site labor, shipping costs, travel, assembly or disas-
sembly, or other charges associated with the repair or replacement of covered components. Further, this warranty does not cover
any problem that is caused by abuse, misuse, commercial or public use of 200 Series models, ordinary wear and tear, outdoor
use, weathering, acts of God (such as wind and lightning), failure to follow directions, improper installation, improper maintenance,
or any silk screened graphics. Rust is a natural occurrence with any steel product and is likewise not covered by this warranty, to
the extent that it does not affect the structural integrity of the part.
JUMPSPORT IS NOT RESPONSIBLE OR LIABLE FOR INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES ARISING
OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THE PRODUCT OR OTHER DAMAGES WITH RE-
SPECT TO ANY LOSS, INCLUDING BUT NOT LIMITED TO ECONOMIC LOSS, LOSS OF PROPERTY, LOSS OF REVENUE
OR PROFITS, LOSS OF ENJOYMENT OR USE, COST OF REMOVAL, INSTALLATION OR OTHER CONSEQUENTIAL DAM-
AGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAG-
ES. ACCORDINGLY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
THE WARRANTY EXTENDED HEREUNDER IS IN LIEU OF ALL OTHER WARRANTIES AND ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS LIMITED IN ITS SCOPE AND DURATION TO THE
TERMS SET FORTH HEREIN. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS. ACCORDINGLY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
How to get a defective part replaced:
1) Call the JumpSport Customer Service department at 1-877-507-1399 to obtain a Return Authorization number. All returns must
be pre-authorized.
2) Send the part(s) to the designated Service Center, along with a copy of your original sales receipt and a brief written descript
tion of the problem, including how it occurred. You must pay freight and insurance to return the part to JumpSport. At Jump
Sport’s sole discretion, we may ask you to send photographs in addition to or in lieu of returning the part.
3) After inspecting the returned part(s), JumpSport will make a final determination whether the part is covered by this warranty.
We reserve the right to examine photographs or physical evidence concerning parts claimed to be defective prior to making a
final determination concerning the claim. A repaired or replacement part will be returned to you. (Shipping charges may apply.)
Please allow 3 to 4 weeks for delivery."
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
*Only the models in our 300 and 500 Series of Fitness Trampolines are approved for commercial use. When used
in a commercial setting, the commercial warranty applies.
Private Use Commercial Use
(Series 300/500 Only)
Steel Frame & Legs Lifetime 5 years
Series 200 Jumping Surface and EnduroLast Cords* 2 years* n/a
Series 300 Jumping Surface and EnduroLast Cords* 3 years* 12 months* (Except the 370)
Series 300 PRO Jumping Surface and EnduroLast Cords* 4 years* 18 months* (Plus the 370) / 1 year on Jumping
Surface
Series 500 PRO Jumping Surface and EnduroLast Cords* 5 years* 18 months* / 1 year on Jumping Surface
All other components (including hinges) 1 year 1 year
4
*Mat and cord warranty are limited to only one (1) usage replacement during applicable period.