Juniper SRX5600 Instruction Manual

Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet
The services gateway can be installed in a four-post rack or cabinet or an open-frame
rack. Install the mounting hardware on the rack before installing the services gateway.
Install the mounting shelf, which is included in the shipping container, before installing
the services gateway. We recommend that you install the mounting shelf because
the weight of a fully loaded chassis can be up to 163.5 lb (74.2 kg).
Table 1 specifies the holes in which you insert cage nuts and screws to install the
mounting hardware required (an Xindicates a mounting hole location). The hole
distances are relative to one of the standard U divisions on the rack. The bottom of
all mounting shelves is at 0.02 in. above a U division.
Table 1: Four-Post Rack or Cabinet Mounting Hole Locations
Mounting ShelfDistance Above U DivisionHole
X
1.14 U2.00 in. (5.1 cm)4
X
0.86 U1.51 in. (3.8 cm)3
X
0.50 U0.88 in. (2.2 cm)2
X
0.14 U0.25 in. (0.6 cm)1
To install the mounting shelf on the front rails of a four-post rack or cabinet, or the
rails of an open-frame rack (see Figure 1 or Figure 2):
1. If needed, install cage nuts in the holes specified in Table 1.
2. On the back of each rack rail, partially insert a mounting screw into the lowest
hole specified in Table 1.
3. Install the mounting shelf on the back of the rack rails. Rest the bottom slot of
each flange on a mounting screw.
4. Partially insert the remaining screws into the open holes in each flange of the
mounting shelf.
5. Tighten all the screws completely.
Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet ■1

Figure 1: Installing the Front Mounting Hardware for a Four-Post Rack or Cabinet
2■Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet

Figure 2: Installing the Mounting Hardware for an Open-Frame Rack
Related Topics ■Overview of Installing the SRX5600 Services Gateway
■Site Preparation Checklist for the SRX5600 Services Gateway
■Tools Required to Install the SRX5600 Services Gateway with a Mechanical Lift
■Unpacking the SRX5600 Services Gateway
■Installing the SRX5600 Services Gateway Using a Mechanical Lift
■Moving the Mounting Brackets for Center-Mounting the SRX5600 Services
Gateway
Published: 2009-11-03
Installing the SRX5600 Services Gateway Mounting Hardware for a Rack or Cabinet ■3