Justin Jb-20-6000 User manual

BEFORE INSTALLING AND USING THE PRODUCT,

PLEASE READ THE INSTRUCTIONS THOROUGHLY,

AND RETAIN THEM FOR FUTURE REFERENCE.

PRODUCT OVERVIEW

1. Micro USB Input Port

2. LED Indicator Lights

3. Power Button

4. USB Output Port

Included: (1x) Power Bank and Charging Cable (1x)

SPECIFICATIONS

To ensure safe operation, check your device’s

compatibility with Power Bank speciﬁcations prior to use

CHECKING POWER LEVELS

USE

Before ﬁrst use, it is recommended to charge the Power

Bank via the supplied USB Charging Cable. The Power

Bank will take approximately 8 hours to charge 0-100%.

1. Charging the Power Bank:

Plug the supplied Micro USB Charging Cable into the

Power Bank’s Micro USB input. Next, insert the USB

end of the Charging Cable into a computer or AC

power source with a USB Output Port of 5V. While

charging, the 4 blue LED Indicator Lights will FLASH

to show the power level. When the Power Bank is fully

charged, all 4 LEDs will stop ﬂashing and stay lit.

See “Checking Power Levels”.

2. Charging Your Smartphone, Etc:

Using your device’s supplied charging cable (Apple®

Lightning™cable, Micro USB cable, etc.), plug your

smartphone, tablet or other USB powered device into

the USB Output Port of the Power Bank. Press the

Power Button on the Power Bank to begin charging

your device (LEDs will stay lit for approx. 5 seconds).

Charging will continue until your device is fully charged

or the Power Bank has drained. To manually stop

charging, simply disconnect your device.

PLEASE NOTE

•

The Power Bank comes pre-packaged with a partial

charge, NOT a full charge. We recommend fully charging

your Power Bank before ﬁrst use for best performance.

• The Power Bank’s LED Indicator represents the

estimated power levels. Actual charge may vary.

• If your device (smartphone, tablet, etc.) is not charging,

this may be a sign that the battery level of the Power

Bank is very low and you need to recharge it.

• Your Power Bank includes a special Micro USB to USB

cable. Some devices, namely BlackBerry®devices,

REQUIRE this cable for charging. If you do not use this

cable, your device might not charge.

• Some devices require you to turn OFF the device prior

to charging via the Power Bank. If the device is left ON

and plugged into the Power Bank, the tablet will show

a small red “X” over the battery icon signifying that the

tablet is not charging. There is no need for concern,

this will not harm your device. Simply turn OFF your

device to continue charging.

• It is normal for the Power Bank to become slightly

warm during use.

MAINTENANCE

In order to keep your Power Bank operating at maximum

potential, please follow these guidelines:

1. Recharge the Power Bank every 2 months when not in

use. Charge to at least 40%, as this will extend the

battery life.

2. Keep your Power Bank dry and away from moist and

corrosive materials. DO NOT get wet. In addition,

never expose to high heat environments. Avoid

extreme temperatures of hot or cold as it will decrease

the overall battery performance.

CAUTIONS

Please read this section carefully before using.

• Only use this product with conﬁrmed power sources

that follow device speciﬁcations. Device is intended to

be used with iPhone®, mobile phones and other digital

products. Only use speciﬁed charging methods or

reputable branded chargers that are compatible with

speciﬁed device speciﬁcations.

• Do not use product beside or in close proximity to a

heat source such as a ventilation heat vent, convection

heater, burner, etc.

• Do not expose device to moisture or submerge it in

liquid. Do not leave device inside an excessively hot or

cold environment. Store device in a cool and dry

environment at all times.

• Avoid dropping or applying excessive shock and force

to device. Do not use in unprotected outdoor

environments or in exposed sunlight for a prolonged

period of time.

• Do not use device in a conﬁned space. Restricted or

insufﬁcient airﬂow will put device at risk of overheating.

• Avoid touching metal prongs when plugging and

unplugging device from power source.

• Do not use harsh chemicals to clean device. Use a

damp cloth with warm water to wipe off any dirt. Only

clean the device when it is unplugged from any power

source.

• Ensure charge port is clear of any foreign objects

before using. Do not force incompatible connectors

into any port.

• Do not used damaged cables and wires with device.

• Do not attempt to disassemble the device. Any

attempts to do so will void all warranties on this

product. Do not attempt to remove or salvage

batteries for other purposes.

SAFETY INSTRUCTIONS

Read all instructions and warnings prior to using this

product. This device contains a Lithium-Ion (Li-Ion)

Battery. Improper use, storage and disposal may cause

leaks, expansions and explosions that could lead to ﬁres,

health concerns, bodily injury and property damage.

• Upon the event where the device may be broken,

shattered, or in any way physically compromised DO

NOT USE.

• Do not dispose device into standard garbage disposal

sites. Dispose of device at available Battery Recycling

Sites after fully discharging battery. Not doing so may

violate local disposal laws and regulations.

• NOTE: Opening of product and/or removal of battery

will render product inoperative and voids manufacturer

warranties, dispose of remaining product components

in accordance with local laws.

• If unusual expansion is detected, disuse device

immediately. In case of ﬁre, use lithium approved

“Class D Type” Fire Extinguishers on device.

• Do not expose or dispose of device into ﬁre.

• In the unfortunate case of a leak and electrolyte comes

in contact with skin, wash area with water and soap.

If electrolyte makes contact with eyes, ﬂush with

generous amounts of water for 15 minutes and seek

medical attention immediately. Avoid inhaling fumes if

applicable. Do not attempt to reuse damaged device.

• Do not charge device with unspeciﬁed power source.

Only use speciﬁed method of charge and reputable

brand OEM chargers compatible with device

speciﬁcations.

FCC STATEMENT

Warning: Changes or modiﬁcations to this unit not

expressly approved by the party responsible for

compliance could void the user authority to operate the

equipment.

NOTE: This equipment has been tested and found to

comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio or television reception, which can

be determined by turning the equipment off and on.

The user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

the receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC

RULES. OPERATION IS SUBJECT TO THE FOLLOWING

TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE

HARMFUL INTERFERENCE, AND (2) THIS DEVICE

MUST ACCEPT ANY INTERFERENCE RECEIVED,

INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

CALIFORNIA PROP 65 WARNING

WARNING: This product contains chemicals known to

the State of California to cause birth defects or other

reproductive harm. For more information on these

regulations and a list of chemicals, log on the following

website address: http://www.oehha.ca.gov/prop65.html

INNOVATIVE TECHNOLOGY ELECTRONICS CORP.

LIMITED WARRANTY: 90 DAYS LABOR, ONE YEAR PARTS

Innovative Technology Electronics Corp. (IT) warrants the product to be free from

“Defects” in materials under normal use for a period of “One Year” from the date of

the original purchase. The Warranty is “Not” transferable. IT agrees, within the

initial “90 Day” period, to repair or replace the product if it is determined to be

defective at “No Charge”. It is further agreed that IT will cover the cost to repair or

replace damaged “Parts” only for a total period of “One Year” from the date of the

original purchase. The warranty does not cover cosmetic damage, antennas, AC

cords, cabinets, headbands, ear-pads, or damage due to line power surges,

connection to improper voltage supply or settings, misuse, mishandling, accident,

acts of God or attempted repair by an unauthorized service agent.

To obtain service, the purchaser MUST present an original sales receipt / proof of

purchase. Please contact us at www.ithomeproducts.com to request an RMA (Return

Material Authorization) number to return products for service or replacement. Returns

without an RMA number on the package will be refused and returned to sender.

Upon receipt of the returning item and our full inspection (IT) may issue a

replacement to customer for the same item or of one that has equivalent value and

features. To return an item, supply full name, return address, phone number, item

purchased, receipt of purchase and reason for return to obtain RMA number.

All returns must be in the original packaging or reasonable substitute to prevent

damage. Customer “Must” include full name, shipping address and telephone

number inside of package. No return will be shipped back to a PO Box or

APO address.

Please include your check or money order in the amount of:

•USD$5.00 for items $10.00 to $39.99 (Price Paid Per Unit)

•USD$10.00 for items $40.00 to $99.99. (Price Paid Per Unit)

•USD$16.00, for items $100.00 and up. (Price Paid Per Unit)

•Shipping fees are non-refundable

To be payable to Innovative Technology Electronics Corp.(for handling and return

shipping charges) (IT) will not be responsible for delays or unprocessed claims

resulting from a purchaser’s failure to provide any / all of the necessary

information. Send all inquiries or RMA request via our website:

www.ithomeproducts.com/support.

Innovative Technology Electronics Corp.

1 Channel Drive, Port Washington, NY 11050

Toll free: 1-877-483-2497

Website for support: www.ithomeproducts.com/support

There are no express warranties except as listed above.

REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE

EXCLUSIVE REMEDY OF THE CUSTOMER, (IT) SHALL NOT BE LIABLE FOR ANY

INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR

IMPLIED WARRANTY ON THIS PRODUCT EXCEPT TO THE EXTENT PROHIBITED BY

APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO THE

DURATION OF THIS WARRANTY.

Some states do not allow the exclusion or limitation of incidental or consequential

damages, or limitations on how long an implied warranty lasts, so the above

exclusions or limitations may not apply to you. This warranty gives you specific

legal rights and you may also have other rights, which vary from state to state.

NOTE: As a result of continual improvements, the

design and speciﬁcations of this product are

subject to change without notice.

Apple and iPhone are trademarks of Apple Inc., registered in the U.S.

and other countries. Lightning is a trademark of Apple Inc. Lightning

cord NOT included. Smartphones and Tablets are NOT included.

CAN ICES-3 (B) / NMB-3 (B)

6,000mAh Power Bank

With Built-In Stand

Model:

JB-20-6000

USER MANUAL