Juvo A3 User manual

Maintenance
Troubleshooting
Safety Warnings
JUVO Guarantee Terms and Conditions
Time Atelier, LLC P.O. Box 3548, Cedar Park, Texas 78630
www.juvoluxury.com
Product Manual
A3 Watch Winder
Your JUVO watch winder does not require any special maintenance. We recommend you
clean it regularly with the microfibre cloth provided.
If your JUVO watch winder stops functioning, or no longer functions normally, check the
following points.
Make sure the power switch is NOT in the off position.
If the watch winder still fails to function, unplug the adaptor from the adaptor port to reset
the watch winder. And then insert the adaptor into the adaptor port again.
Only use the adaptor supplied with this watch winder.
ALWAYS turn off the power before inserting or taking out watches.
Unplug the adaptor when the watch winder is not being used.
For watch winders that use both adaptors and batteries, always remove the batteries when
using the adaptor.
DO NOT rotate the winder turntable at any time.
DO NOT place the watch winder in direct sunlight or in environments that are either damp
or dusty.
Guarantee validation.
Your JUVO watch winder is guaranteed for 2 years, from the date of purchase, against any
manufacturing defect.
The guarantee is only applicable on presentation of a valid valid proof of purchase.
The guarantee excludes the following.
Damage resulting from normal use eg. scratches, stains, marks and discolouration.
Damage resulting from improper or inappropriate use of the product, such as non-respect of
battery polarity, mistreatment of the case, shocks, breakage, etc.
Damage resulting from use of the winder in an unsuitable environment, such as damp
places, exposure to water, vibrations, sources of excessive heat, etc.

Box contents
Pouch contents
・Watch Winder x 1 ・Watch Pillow x 3 ・Power Adaptor x1
・Product Manual ・Microfibre ・Pair of White ・Key x 2
& Guarantee Card x 1 Cloth x 1 Gloves x 1
Adaptor port
Glass door
Product Specifications
Power Input: AC/100-240V, 50-60Hz; Output: DC/12V 1.5A
200 x 200 x 407mm (L x W x H)
6.6kg (without adaptor)
Operate between 5℃ ~ 40℃ AC Adaptor
Features
Size
Weight
AccessoryTemperature
Thank you for purchasing this JUVO Watch Winder, please take a few minutes to read
through the Quick Start Guide to ensure correct operation. You can view the product
manual, instructional video, and tips on JUVO website: www.juvoluxury.com
TPD (Turns Per Day)
Mode A: Revolves for 7 minutes – stops for 103 minutes then repeats, 650TPD.
Mode B: Revolves for 7 minutes – stops for 73 minutes then repeats, 900TPD.
Mode C: Revolves for 7 minutes – stops for 53 minutes then repeats, 1200TPD.
Mode D: Revolves for 7 minutes – stops for 41 minutes then repeats, 1500TPD.
Operations for Use
Insert the adaptor into the adaptor port and plug it into the electrical outlet.
Open the glass door and carefully pull out the watch pillow using your forefinger and thumb.
Place the watch on the watch pillow.
Place the watch pillow back in the winder.
Close the cover.
To start operation, please use the TPD switch to set the TPD (Turns Per Day) and use the
mode switch to set the rotating direction you require
Turn the LED light switch on back of the winder to desired light brightness – off, low,
medium and high.
TPD switch Mode switch
A
B
CD
Mode
Anti-clockwise
OFF
Low
Medium
High
LED light switch with 4 settings
Locking/unlocking the winder door
Watch Pillow: By turning the watch pillow 90 degree
For Average Wrist For Oversize Wrist
NOTE: We do NOT recommend watches weighing over 350 grams for this winder.
We also do NOT recommend metal bands longer than 235 mm in length (with metal
bands buckled and including the watch dial diameter)as it may prevent proper
operation of the winder.