JVC HA-NP35T User manual

1/19/23, 11:36 AM
Restoring the settings to the initial state | HA-NP35T | User manual
https://manual3.jvckenwood.com/accessory/headphones/contents/ha-np35t/en/YRWWSYymkvhtrf.php
1/3
> When in Trouble > Restoring the settings to the initial state
Restoring the settings to the initial state
If no sound is heard from one side of the earphones or the earphones cannot be
connected to your BLUETOOTH device, restoring the settings of earphones to the
initial state may solve the problem.
Information of all the paired devices will be deleted (initialized). Perform pairing
again from the start.
Start by deleting the registration information of this unit from the BLUETOOTH
setting on the BLUETOOTH device. Charge the charging case.
1Insert the L and R earphones into the charging case.
The earphones are charged and the L and R indicators light up.
2Press and hold the L touch sensor area for about 15 seconds until
the L indicator flashes twice.

1/19/23, 11:36 AM
Restoring the settings to the initial state | HA-NP35T | User manual
https://manual3.jvckenwood.com/accessory/headphones/contents/ha-np35t/en/YRWWSYymkvhtrf.php
2/3
After the indicator has flashed, the earphone is charged and the indicator
lights up.
If the indicator does not flash, repeat step 2 from the beginning.
3Press and hold the R touch sensor area for about 15 seconds until
the R indicator flashes twice.
After the indicator has flashed, the earphone is charged and the indicator
lights up.
If the indicator does not flash, repeat step 3 from the beginning.
4Remove the earphones from the charging case and set the L and R
earphones side by side.
The L and R indicators light up and the power turns on.
5After a while, the L and R earphones are connected to each other
and the R indicator starts to flash slowly (once every 5 seconds).
Then the L indicator starts to flash quickly and repeatedly.

1/19/23, 11:36 AM
Restoring the settings to the initial state | HA-NP35T | User manual
https://manual3.jvckenwood.com/accessory/headphones/contents/ha-np35t/en/YRWWSYymkvhtrf.php
3/3
Back Next
The settings are restored to the initial state (factory default).
When the L and R indicators flash quickly, the earphones are now ready for
device pairing. Pair the earphones with a device. Pairing (Registering a
device)
When the sound only emits from one side of the earphones even when the
earphones are connected to the BLUETOOTH device, touch and hold the touch
sensor area on both earphones again to turn off the power and repeat the
steps from the beginning.
Top of page
Contact & Support (English Only)
© 2022 JVCKENWOOD Corporation
WIRELESS HEADPHONES HA-NP35T