JVC LT-19HA72U User manual

VOL CH
REC
FREEZE
MENU
LT-19HA72U
LT-22HG72U
LT-28HA72U
EnglishFrenchDutchSpanish
Operating Instructions
Mode d'emploi
Handleiding
Instrucciones de Funcionamiento
Downloaded from www.vandenborre.be

EN 2
You get the smartcard from your cable supplier (CAMs are customary). Insert the
smartcard into the CAM, and then insert the CAM into the CI slot of your TV set.
modules
EN
KESA Electricals SAS 37 Rue dela Victoire, 75009 Paris, France
Downloaded from www.vandenborre.be

Features...............................................................................................2
Contents...............................................................................................3
Important Safety Information...................................................................4-8
Installation............................................................................................9-12
Remote Control .....................................................................
Operation.............................................................................................
Troubleshooting table............................................................................
Specification.........................................................................................
License Information...............................................................................
................ 13-14
15-24
25-29
30
31
EN
3
EN
Downloaded from www.vandenborre.be

EN 4
it is damaged.
broken glass. You could be hurt or the unit could become damaged.
to allow for air circulation.
EN
100-240V~50/60Hz
Downloaded from www.vandenborre.be

LT-19../LT-22.... LT-28....
EN
5
Carefully hold the base plate in position and secure it with screws.
three screws(M4x10mm)
To detach the base plate,perform these steps in reverse order.
For wall mounting,the base must be dismantled.To do this,remove screws from the back.
(LT-19.../LT-22...:100x100mm,LT-28...:200x100mm).
Remove the stand as one piece by reversing the fixing procedure described above.
You can refit the screws to the stand for safe keeping, but tighten them only slightly.
FIXING SCREWS
2x4mmx 5mm (TOP HOLES)
2x4mmx 5mm (BOTTOM HOLES)
Protect the screen and lay the TV flat on its face, on a stable table, with the stand foot clear of the
table edge.
To ensure a safe installation, please observe the following when hanging the television on a wall:
Warning: This operation requires two people.
Check that the wall can support the weight of the television set and a VESA-standard wall mount
assembly (not supplied).
Be sure to use only screws suitable for the material of the wall.
In case of any doubt please contact a qualified installer.
Beware of electrical cables, gas and water pipes in the wall.
Follow the instructions provided with the wall mount.
The set must be installed on a vertical wall.
Make sure that cables are placed so that there is no danger of tripping over them or damaging
them.
one screw(M4x20mm)
four screws(M4x8mm)
three screws(M3x15mm)
fit in
EN
Downloaded from www.vandenborre.be

EN 6
it on the edge.
While cleaning, do not wear jewelry that could cause surface
scratching (such as rings, wrist-watch, etc.).
the
EN
Downloaded from www.vandenborre.be

Safety Information
Dangerous voltage constituting a risk
of electric shock is present inside this
equipment.
This equipment is double insulated
and an earth connection is not
required.
This mark is applied to show the
equipment conforms to European
safety and electro-magnetic
compatibility standards.
Safe use and care of your television
We have designed and made this television to meet
European Safety Standards, but as with any
electronic equipment you must take care, to stay
safe and get the best results. Here is some good
advice to help you do this.
Read these instructions carefully before you try to
use the television.
Protect the mains lead. You must ensure the mains
lead cannot be walked on, crushed, chafed, cut or
trapped.
Switch off the mains power or pull out the mains plug
when you leave the television unattended, unless
the function of the television requires a continuous
power supply.
Do not continue to use your television if you have
spilt liquids in it, if it is damaged in any way or if it
does not work normally. Immediately unplug the
television and get expert advice.
Avoid harsh conditions such as wet or damp places,
high humidity, strong vibration, extremely high or
low temperatures, strong sunlight and places that
are very dusty.
Never fit makeshift stands or legs to the television.
Never push objects into holes and ventilation slots.
To prevent electric shock do not remove any cover.
Do not touch the LED display as it gets warm when
in use, this is normal and is not a fault.
If anything goes wrong do not try to fix it yourself,
get a qualified service agent to look at it.
Pull out the mains plug and disconnect the aerial
lead during thunder storms.
Cleaning
Disconnect the mains supply and use only a lightly
dampened soft cloth. Do not use chemical solvents
or strong detergents as these may damage the
cabinet or screen.
Mains Supply
This television is designed to operate from a 100-
240 Volts 50/60Hz AC mains supply. Other power
sources
may damage it. Check that the rating plate (on the
back cover of the television) states 100-240V AC
before you plug it in for the first time.
The manufacturer accepts NO liability for damage
or injury caused by using the product with the
wrong mains voltage.
Never allow water droplets to remain on the
screen as moisture can cause permanent
discolouration.
Greasy marks must only be removed with a
commercial cleaner specifically recommended for
LED screens.
EN
7
EN
Downloaded from www.vandenborre.be

Safety Information (cont)
Eye Fatigue
When using this product as a computer monitor, health and safety experts recommend short
frequent breaks rather than occasional longer breaks. For example a 5-10 minute break after
an hour of continuous screen work is considered to be better than a 15 min break every 2 hours.
Do not use the monitor against a bright background or where sunlight or other bright light
sources will shine directly onto the screen.
WARNINGS:
This appliance is intended for domestic household use only and should not be used for any
other purpose or on any other application, such as for non-domestic use or use in a commercial
environment.
If the supply cord is damaged it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
This apparatus shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases shall be placed on the apparatus.
No naked flame sources, such as lighted candles should be placed on the apparatus.
The ventilation should not be impeded by covering the ventilation openings, with items such as
newspapers, tablecloths, curtains etc.
WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in
accordance with the installation instructions.
EN 8
EN
Downloaded from www.vandenborre.be

1: Remote Control Sensor.
2:
RED STANDBY.
3: Side buttons
Power Indicator LED: 1. SOURCE:
2. MENU:
3. CH+/CH-:
4. VOL+/VOL-:
5. STANDBY:
Displays the input source menu;
press repeatedly to move down the menu and
press "VOL-" or "VOL+" to select the required
source.
Display main MENU.
In TV mode, press "CH+" or "CH-" to
change the channel up and down. In MENU mode,
press "CH+" or "CH-" to select items. standby
mode, press "CH+" or "CH-" to turn on the TV.
Adjust sound level. In MENU mode,
press "VOL+ " or "VOL- " to adjust the item that
you selected.
Press this button to turn the unit ON
from STANDBY mode. Press it again to turn the set
back to STANDBY.
In
30 30
1
3
2
KEYBOARD
Front panel
SOURCE
MENU
CH+
CH-
VOL+
VOL-
STANDBY
REAR AV Connections
All the terminals are(from left to right):YPbPr INPUT,VIDEO,AUDIO INPUT,COAXIAL OUTPUT,SCART.
Note: VIDEO and YPbPr share one audio channel.
REAR AV Connections(SIDE)
All the terminals are(from left to right):
USB, HDMI2, HDMI1(ARC), HEADPHONE, CI, PC AUDIO, VGA, RF.
Note: 1.When HDMI port gets DVI signal ,the audio signal is received from the PC Audio channel.
2.Insert the plug of the earphone into the headphone jack on the unit.
The speakers are then muted.
VOL CH
FREEZE
EPG
COAXIAL OUTPUT
EN
9
Installation
EN
Downloaded from www.vandenborre.be

STEPS:
PC
Be sure both the TV and computer are set to
Power off.
1.Connect VGA and audio cable.
2.Connect the power cord.
3.Power on the TV, switch to PC mode.
4.Power on the PC.
This sequence is very important.
EN 10
Installation
EN
Downloaded from www.vandenborre.be

PRESET MODE
PC
2
1
3
5
640*480
800*600
1024*768
1366*768
60
60
60
60
31.47
37.88
48.36
47.7
RESOLUTION V.Freq.(Hz) H.Freq.(KHz)
6
1920*1080
(recommended PC fomat for 22") 60 66.64
EN
11
Installation
EN
ANTENNA
Note:
Aerial connections: IEC(female).
Input impendance: 75 unbalanced.
(recommended PC fomat for 19", 28")
1280*960 60 60
1280*720 60 45
1360*768 60 47.7
7
8
9
Downloaded from www.vandenborre.be

EN 12
This TV provides one group of AV, one group of YPbPr and one SCART for convenient
connection to VCR, DVD or other video equipment. Please refer to the owners manual
of the equipment to be connected.
REAR AND SIDE CONNECTIONS
AV EQUIPMENT
It can be connected to the following appliances: VCR, multi disc player, DVD, camcorder,
video game or stereo system, etc.....
YPbPr can support these video formats: 480i,576i,480p,576p,720p,1080i,1080p.
Yellow (video)
White(audio L)
Red(audio R or Pr)
Y
W
R
W R
G B R
Blue(Pb)
Green(Y)
B
G
VIDEO EQUIPMENT with YPbPr
WR
GBR
W R
W R
TO AUDIO OUTPUTS
VIDEO EQUIPMENT
TO VIDEO
OUTPUTS
HDMI
Y
Y
COAXIAL OUTPUT
Installation
EN
Downloaded from www.vandenborre.be

1: :To set the TV to standby or power on.
2: :In USB mode, used as reverse key, in teletext
mode used as subpage key.
3: : In USB mode, used as forward key, in teletext
mode used as reveal key.
4: : Press in USB Mode to begin or continue playback.
5: : Press in USB Playback Mode to pause playback
6: :To enter TELETEXT.
7: : To turn on subtitles press the subtitle button
in DTV mode.
8 : : Displays the main on-screen menu.
9 : : To move within the menu.
10: : Confirms selection.
11: : To display information about the program being viewed
and what's on next in TV mode.
12: :ToaccessyourfavouritechannelslistinTV mode.
13: : To adjust sound level.
14: : For direct access to channels.
15: : To select the available audio language of TV programs .
16: : To disable or enable the sound output.
17: : In USB mode, used as next key, in teletext mode used as
listkey.InTVmodeitlistsTVandRadiochannels.
18: : In USB mode, used as previous key, in teletext mode used
as hold key.
19: :
20: : Press to stop play in USB mode.
21: : To display the program information of the show you
are watching, press the info button.
22: Press to freeze the picture you are watching.
23: : Press to display and select the available video sources.
24: : To return to the previous menu or exit menu.
25: : To access the next or previous channels.
26: :Press to record the TV program you are watching in
DTVMode.
27: :TV Mode: Jumps to last channel viewed.
28. red, green yellow and blue buttons.
.
TEXT
SUBTITLE
MENU
CURSOR
OK
EPG
FAV
VOL+/-
NUMERIC KEY
AUDIO
INFO
FREEZE:
EXIT
CH+/CH-
REC
RECALL
TELETEXT:
In teletext mode used as index/shortcut button for PVR File System.
1
2
3
4
5
6
7
8
9
10
11
13
12
14
15
16
17
18
19
20
21
22
23
24
25
26
27
VOL CH
REC
FREEZE
28
MENU
EN
13
REMOTE CONTROL
EN
Downloaded from www.vandenborre.be

E
SELECTING A PAGE
INDEX
(BUTTON 19)
DIRECT ACCESS
TO THE ITEMS
SUB PAGE
(BUTTON 2)
HOLD
(BUTTON 18)
REVEAL
(BUTTON 3)
Press : You will obtain :
LIST
(BUTTON 17)
TELETEXT
Enter the number of the page required using the 0 to 9 up/down. Example:
page 120, enter 120. The number is displayed top left, the counter turns
and then the page is displayed. Repeat this operation to view another
page. If the counter continues to search, this means that the page is not
transmitted. Select another number.
Coloured areas are displayed at the bottom of the screen. The 4 coloured
keys are used to access the items or corresponding pages. The coloured
areas flash when the item or the page is not yet available.
This returns to the contents page (usually page 100).
Certain pages contain sub-pages which are automatically displayed
successively. This key is used to stop or resume sub-page
acquisition. The number appears top left.
To freeze the page.
To display or hide the concealed information (games solutions).
The user can set four favorite pages to be directly linked to the four colour
keys. The favorite page numbers should be stored and restored to/from
nonvolatile memory for each channel by the system software.
This is used to enter or exit teletext mode. The summary appears with a
list of items that can be accessed. Each item has a corresponding 3 digit
page number.
Teletext is an information system broadcast by certain channels which can be like a
newspaper. It also offers access to subtitles for viewers with hearing problems or who are not
familiar with the transmission language (cable networks, satellite channels, etc.)
read
TEXT
(BUTTON 6)
EN 14
REMOTE CONTROL
EN
Downloaded from www.vandenborre.be

EN
15
OPERATION
EN
Espanol
~
Downloaded from www.vandenborre.be

EN 16
OPERATION
EN
Downloaded from www.vandenborre.be

EN
17
OPERATION
EN
Downloaded from www.vandenborre.be

EN 18
OPERATION
EN
Downloaded from www.vandenborre.be

EN
19
OPERATION
EN
Downloaded from www.vandenborre.be

EN 20
OPERATION
EN
Downloaded from www.vandenborre.be