JVC SP-UXQD9S User manual

SP-UXQD9S INSTRUCTIONS:SPEAKER SYSTEM
 !"#$%&'(
Thank you for purchasing JVC speakers.
Before you begin using them, please read the instructions
carefully to be sure you get the best possible performance. If you
have any questions, consult your JVC dealer.
Precautions
Before connecting:
• Make sure to match the polarity (ªand ·) when connecting
the speaker cords.
• Turn off the power to the amplifier before connecting the
speaker system; otherwise, the speakers may be damaged.
• The impedance of each speaker is 4 Ω.
If this does not match with the speaker impedance range
indicated on the amplifier, you cannot connect this system to
the amplifier.
• The maximum power handling capacity of the SP-UXQD9S is
20 W. Excessive input will result in abnormal noise and
possible damage.
Daily operations and maintenance:
• Be sure to turn down the volume level on the amplifier to
prevent unwanted noise before performing following operations:
– Turning on or off other components,
– Operating the amplifier,
– Tuning FM stations,
– Fast-forwarding a tape,
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds.
– Connecting or disconnecting a microphone.
• When using a microphone, do not aim it at the speakers or use
it near the speakers; otherwise, the howling which occurs may
damage the speakers.
• Before replacing the cartridge, always turn off the power both
to the amplifier and to the turntable; otherwise, the clicking
noise may damage the speakers.
SPEAKER FOR A/V COMBINATION
SP-UXQD9S has a magnetically-shielded design for placement
adjacent to TV’s and monitors without causing color aberrations.
However, color may be affected as a result of how the speaker system
is installed. Therefore, be careful of the following:
1. When placing these speakers near a TV set, turn off the TV’s
main power switch or unplug it before installing the speakers.
Wait at least 30 minutes after the system is installed before turning
on the TV’s power.
2. If another speaker system has been set up near the TV set, that
system may cause color unevenness in the TV’s picture.
3. In spite of the shielded design of these speakers, some types of
TV’s may be affected by them. If this happens, move the speakers
a short distance from the TV set.
 !" JVC  !
 !"#$%&'()*+,!"-./%012'3456
 !"#$%&'()*+ JVC  !"#$%
 !
 !"#$
• !"#$%&'()*+,ª·
• !"#$%&'()*+,-./0#123(4567
 !"#
• !"#$%& 4 Ω
 !"#$%&'()*"+,-#$%./012340
 !"#$%&'()*
•SP-UXQD9S  !"#$% 20 W !"#$%&'(
 !"#$%&'()*+,-./0
 !"#$%
• !"#$%&'()*+,-./0123456789
 !"#
– !"#$%&'
– !"#$%
– FM 
– !"#$
– !"#$%&"'()*+
– !"#$%&
• !"#$%&'()*+,-.%/&',-.01
 !"#$%&'()*+,
• !"#$%&'()*+,-./01*+!23456
 !"#$%&'()*+,-.
^Ls= !"
SP-UXQD9S= !"#$%&'()*+,-./,0123
 !"#$%&'()*+$%,-./01234567*
 !"#$%&'()*+
1.  !"#$%&'()*+,-$./0123!"#45
 !"#$%&'()*+,-./0123456
30= !"#$%&'(%)*
2.  !"#$%&'()*+,-./0123&'4567
 !"#$%&'()*
3.  !"#$%&'()*+,-.(!/0123456
 !"#$%&'()*+,-./012345678

LVT1270-002A
[UF]

RIGHT LEFT
RIGHT LEFT
© 2005 Victor Company of Japan, Limited
EN, CS
Specifications
Type : 3-Way Bass-Reflex Type
(Magnetically-Shielded Type)
Speakers:
Woofer : 10.0 cm cone ×1
Midrange : 4.0 cm cone ×1
Tweeter : 1.5 cm dome ×1
Power Handling Capacity : 20 W
Impedance : 4 Ω
Frequency Range : 55 Hz to 40 000 Hz
Sound Pressure Level : 85 dB/W•m
Dimensions (W ×H ×D) : 140 mm ×231 mm ×204.5 mm
Mass : 2.2 kg each
Design and specifications subject to change without notice.
Right speaker
 !"
Left speaker
 !"
Red
 Red

Black


 :3 !"#
E F
 :
 !" : 10.0 cm  ×1
 !" : 4.0 cm  ×1
 !" : 1.5 cm  ×1
 ! : 20 W
 : 4 Ω
 ! : 55 Hz 40 000 Hz
 ! : 85 dB/W•m
 (××) : 140 mm ×231 mm ×204.5 mm
 : 2.2 kg
 !"#$%&'()*+,-.
Connecting the speaker system to the amplifier
 !"#$%&'()*!+
Amplifier output terminals
 !"#$
Black

Speakercord
 !"
0305NSMMAMJSC
Speaker Cover
 !"
Speaker cover can be detached
 !"#$%
 !"#$%&'JVC !"#
 !"#$%&'()*+,-.)/068