JVC MX-KC2 Administrator Guide

SCHEMATIC DIAGRAMS
MX-KC2
Contents
  
Block diagram
Standard schematic diagrams
Printed circuit boards
2-1
2-2
2-8 to 10
CD-ROM No.SML200507
COMPACT COMPONENT SYSTEM
No.MB394SCH
2005/7
COPYRIGHT 2005 Victor Company of Japan, Limited.
Lead free solder used in the board (material : Sn-Ag-Cu, melting point : 219 Centigrade)
CA-MXKC2 SP-MXKC2SP-MXKC2
Area suffix
C ------------------------- Canada

In regard with component parts appearing on the silk-screen printed side (parts side) of the PWB diagrams, the
parts that are printed over with black such as the resistor ( ), diode ( ) and ICP ( ) or identified by the " "
mark nearby are critical for safety.

2-1
Block diagram

2-2
Parts are safety assurance parts.
When replacing those parts make
sure to use the specified one.
Standard schematic diagrams
Primary section

2-3
Power amp. section

2-4
Micon section

2-5
Souce selector section

2-6
CD section

2-7
Front section

2-8
Printed circuit boards
Main board
Lead free solder used in the board (material : Sn-Ag-Cu, melting point : 219 Centigrade)
forward side reverse side

2-9
forward side reverse side
Power board
Lead free solder used in the board (material : Sn-Ag-Cu, melting point : 219 Centigrade)

2-10
Front board
forward side
reverse side
Lead free solder used in the board (material : Sn-Ag-Cu, melting point : 219 Centigrade) Trans board Lead free solder used in the board (material : Sn-Ag-Cu, melting point : 219 Centigrade)

< MEMO >

Victor Company of Japan, Limited
(No.MB394SCH)
Printed in Japan
VPT
AV & MULTIMEDIA COMPANY AUDIO/VIDEO SYSTEMS CATEGORY 10-1,1chome,Ohwatari-machi,Maebashi-city,371-8543,Japan