König Electronic Sec-UTS31 User manual

Passive,no need for additional power supply
Using single piece CAT5/5E/6 cable;
Extend YPbPr or composite video&audio up to 60m;
P
Metal outer shell,super interference rejection
Super surge&transcient protection;
Real-time transmission,no delay;
lug and play,simple installation;
Panel Diagram
Features
Front
123
NO. Component Description
3
1
2
RJ45
4
Please refer to "how to make RJ45 plug"
Passive YPbPr Transceiver
2
1
UTP CAT5/5E/6 Cable
Typical Application
DVD/EV D
Monitor
RJ45 Pr
Y
Video
Pb
Audio L
Audio R
Rear
4
RCA-F
RCA-F
RCA-F
Y/Video signal input/output
Pb/Audio signal input/output
Pr/Audio signal input/output
1.Switch off power supply,or else installation with power may damage devices;
2.Check if UTP cables to be used are available;
3.Connect the source of signal with transmitter via RCA cable;
4.Connect the transmitter and the receiver via UTP cable;
5.Connect the receiver with remote devices(for example:monitor) via RCA cable
6. Power relative devices.
Installation Procedure
The product is single channel passive (non-amplified) YPbPr/Composite A/V transceiver.It allows transmission
of real-time and high-performance YPbPr or Composite Audio&Video over one piece UTP
cable.It can be used as either transmitter or receiver.
Please follow the next installation steps:
Passiv e YPbPr Transceiver

Specification
4
3
Passiv e YPbPr Transceiver
Instruments to be used: wire crimper, network tester.
Wire sequence of RJ45 plug should conform with EIA/TIA568A or 568B.
1. Shuck off about 2cm long the insulating layer, and bar the 4 pairs UTP cable.
2. Depart the 4 pairs UTP cable and straighten them.
3. Line up the 8 pieces of cables per EIA/TIA 568A or 568B.
4. Brunt cut the cables to leave 1.5cm bare wire.
5. Plug 8 cables into RJ45 plug, make sure each cable is in each pin.
6. Then use wire crimper to crimp it.
7. Repeat above 5 steps to make the another end.
8. Using network tester to test the cable whether is working.
How to make RJ 45 Plug
RJ 45 PIN Diagram
EIA/TIA 568A EIA/TIA 568B
GND
GND
Pb-
Y-
Pb+
Pr-
Y+
Pr+
1
2
3
4
5
6
7
8
Check if it’s according to the manual;
the real distance not exceeds the allowed transmission distance;
Make sure the cables are quality;
Replace the device at question by a normal working device;
Please contact your vendor if trouble still exists.
If choose RJ-45,make sure both ends of UTP cable are same(both 568A or both 568B)
Make sure
连接接口
Troubleshooting
If any trouble in installation,please follow these steps:Attention:
If choose green terminal block,cable of same color should be in the same pin.
When choose RJ-45,make sure if one end is EIA/TIA568A,the other end should also be
EIA/TIA568A.
or if one end is EIA/TIA568B,the other end should also be EIA/TIA568B.
Channels
3Pin RCA-F
1Channel
Video&Audio
Properties
Function
Video Input
Compatible With
Video Signal Band
Audio Signal Input Format
Transcient&Surge Protection
ESD
Reliability MTBF
Physical
Properties
Size（LWH）
Outer Shell
Color
N.W.
>10000H
104*68*28mm
Aluminum Alloy
Black
Environmental
Operation Temperature
Storage Temperature
-20 -55℃ ℃
-40 -80℃ ℃
116g
Relative Humidity 0-95%（non-condensing)
Left+Right Stereo Audio
50MHz
YPbPr, YCbCr, PAL, NTSC
UTP Cable Connector RJ45
Protection
Transmission Distance up to 300m
Item Description
Audio Signal Output Format Left+Right Stereo Audio
Audio Signal Band
50-20KHz
Specifications suject to change without notice.
Contact Discharge:6000V Air Discharge:8000V
Per:IEC61000-4-2
1KV(10/700us)
Per:IEC61000-4-5
Package Contents
(1 pc)
(1 pc)
Passive YPbPr Transceiver
Application Manual
Passiv e YPbPr Transceiver
Pin Diagram
video
video
Power -
Power -
Power -
Power +
Power +
Power +
1
2
3
4
5
6
7
8
Pin Diagram
video
video
Power -
Power -
Power -
Power +
Power +
Power +
1
2
3
4
5
6
7
8
GND
GND
Pb-
Y-
Pb+
Pr-
Y+
Pr+
1
2
3
4
5
6
7
8