Silicone
Adhesive
5/16"3/16"
100%
Silicone
Sealant
Plus:
• Fasteners
2Mark the centerline on the floor
and wall.
32-5/8"
(829 mm)
1Install 2x6 backing behind the
finished wall.
Instructions are for installation to
wood frame construction. For other
installations, use bracing and
fasteners of sufficient size and
strength.
CAUTION: Risk of personal
injury.
Product can break, chip, and cause
injury if handled carelessly. Get help
lifting the lavatory.
Record your model number below
for future reference:
8"
(203 mm)
4"
(102 mm) 2"
(51 mm)
8"
(203 mm)
7Using a compass, locate and
draw an outline of the faucet
holes on the top of the table.
6Drill 3/16" pilot holes. Level and
secure the mounting brackets
with appropriate fasteners.
5Secure the leg frame brackets to
the wall with appropriate
fasteners. The setscrew notch
should face the floor.
12-1/8"
(308 mm)
27-1/4"
(692 mm)
32-1/8"
(816 mm)
9"
(229 mm)
1-3/16"
(30 mm)
4Measure and mark the hole
locations on the wall on both
sides of the centerline.
12-1/8"
(308 mm)
16-5/8"
(422 mm)
Ø 5/16"
(8 mm)
3Mark the floor where shown, and
drill two 5/16" (8 mm) holes 1/2"
(13 mm) deep.
12Rotate the clips over the rim.
Tighten the fasteners and trim
excess fastener length. Wipe
away excess 100% silicone
sealant.
11Place the table upside down.
Position the sink over the hole.
10Generously apply 100% silicone
sealant around the rim of the
sink.
9Use the punch and a file to
enlarge the hole as needed.
8On the top of the table, position
a punch in the center of the
marked hole. Gently tap the
punch with a hammer.
17Insert the threaded adjustment
pads into the floor holes.
Assemble the leg frame
assemblies to the leg frame
brackets. Tighten the setscrews.
16Assemble and press together the
leg frame assemblies. Secure
with the setscrews.
1/2"
(13 mm)
Max
15Assemble the bracket,
escutcheon, nut, and bolt. The
bolt should stick up no more than
1/2" (13 mm) higher than the
escutcheon.
14Install a threaded adjustment pad
into each leg support.
13Install the faucet.
1295309-2-D
