Kärcher KM 100 BP User manual

QUICKSTART
5.963-997.0 06/11
Warning
These are only brief instructions! Please read and comply with these instructions prior to using or servicing your
appliance.
The non-compliance of the operating and safety instructions may lead to damage of the appliance and to risks for
the operator and other persons.
Start up
1A
A
B
B
C
C
Bp model
A Open the device hood.
B Switch off the charger and remove the plug
from the socket.
Pull the battery cable from the charger cable
and connect it to the appliance.
C Close cover.
Bp Pack model
A Open the device hood.
B Unplug the charger from the mains.
Place the mains cable into the storage
compartment.
C Close cover.
2A B Ajdust the seat
A Pull seat adjustment lever inwards.
B Move seat, release lever and
lock in place.
Check that the seat is properly locked in
position by attempting to move it backwards
and forwards.
Operation
1A
D
B C Starting the machine
A Sit on the driver's seat.
B Do NOT press the accelerator pedal.
C Set programme switch to stage 1 (driving).
D Turn the ignition key to position "I" - the bat-
tery display lights up.
KM 100/100 R Bp/Bp Pack

QUICKSTART
5.963-997.0 06/11
2ABCDrive the machine
A Press slowly the accelerator pedal "forward".
B Press slowly the accelerator pedal "reverse".
C Release the accelerator pedal, the machine
brakes automatically and stops.
3ASweeping with sweep roller
A Set programme switch to stage 2.
Roller brush is lowered.
4ASweeping with side brushes
A Set programme switch to stage 3.
The side brushes and roller brush are
lowered.
5ASweeping with raised
coarse waste flap
A Pushthecoarsewasteflappedaltowardsthe
front
and hold it there.
To lower it, take foot off pedal.
6ASweeping damp or wet floors
A Open wet/dry flap.
7ABCCleaning the dust filter
A Open wet/dry flap.
B Depending on the amount of the collected
dust, the
dust filter should be cleaned every
15-30 minutes during operation.
C Close wet/dry flap
8AEmptying waste container
A Slightly lift and
pull out the waste container.
Empty waste container.
Slide in the waste container and
snap it in place.
Empty the opposite
waste container.
Operation

QUICKSTART
5.963-997.0 06/11
Finish operation
1A B Turn off the appliance
A Set programme switch to stage 1 (driving)
. The side brushes and roller brush are
raised.
B Turn main key to "0" and remove it.
2AEmptying waste container
A Slightly lift and
pull out the waste container.
Empty waste container.
Slide in the waste container and
snap it in place.
Empty the opposite
waste container.
3A
A
B
B
C
C
Bp model
A Open the device hood.
B Remove battery plug and join it to the charg-
ing cable.
Switching on the charger
C Close cover.
Bp Pack model
A Open the device hood.
B Remove the mains cable from the
storage bin.
Connect the charger to the mains and
turn it on.
C Close cover.
Maintenance and care
daily weekly Kärcher Customer Service
1AA Check the sweeping roller and the
side brush for wear and wrapped
belts.

QUICKSTART
5.963-997.0 06/11
2A B A Check dust filter and clean filter
box, if required.
B Clean the machine with a damp
cloth which has been soaked in
mild detergent.
몇Warning
Riskofdamage!Donotwashdownthe
appliance with water and do not use
aggressive detergents.
Troubleshooting
1A
C
B
DE
Appliance cannot be started
A Sit on the driver seat, the
seat contact switch gets activated
B Turn the ignition key to position "I" -
the battery display lights up.
CBp model
Remove battery plug and join it to the
charging cable.
Switching on the charger
DBp Pack model
Remove the mains cable from the
storage bin.
Connect the charger to the mains and
turn it on.
E Release emergency-stop button.
2AEngine is running but machine is not moving
A Check setting of freewheel lever
3A B Machine is not sweeping properly
A Checkrollerbrushandsidebrushesforwear,
replace if necessary.
B Check function of bulk waste flap
Maintenance and care
daily weekly Kärcher Customer Service

QUICKSTART
5.963-997.0 06/11
4A
C
BDust gathers in the machine
A Empty waste container
B Check, clean or
replace dust filter
C Close wet/dry flap
Roller brush does not turn.
A Remove belts or cords from roller brush
Troubleshooting