KARUIZAWA KSF1613 User manual

Stand Fan
User Manual
Model No.: KSF1613
*Before operating the unit, please read this manual thoroughly and retain it for future
reference.

CONTENT PAGE
SAFETY INSTRUCTION 3
PARTS DESCRIPTION 4
INSTALLATION INSTRUCTION 4
OPERATION INSTRUCTION 6
MAINTENANCE INSTRUCTION 7
SPECIFICATION 7
WARRANTY 8
SAFETY INSTRUCTION
1. To avoid electric shock, risk of fire or injury, please read the user manual carefully before using
the appliance and keep it for future reference.
2. This appliance is for household use only. Please use suitable power source (220V/50Hz).
3. Never immerse the appliance in water or other liquids.
4. Do not use the appliance under direct sunshine.
5. Please turn off the appliance when not in use otherwise it may result in danger.
6. Please turn off the appliance and unplug the socket when unattended otherwise it may result in
danger.
7. The appliance is not intended for used by children or persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction.
8. Children should be supervised to ensure that they do not play with the appliance and keep away
from it.
9. With any indication of malfunction (including power cord), please stop using the appliance
immediately to avoid hazard. Take it to the authorized service center for repair. Do not attempt
to repair or change any parts by yourself.
10. Please turn off and unplug the appliance before cleaning or maintenance.
11. Clean the surface of the appliance with damp cloth (or add some detergent). Do not use
corrosive detergent or solvent to clean. Do not swash the appliance with water. Make sure the
appliance is dry before use it again.
12. Please turn off and unplug the appliance when not in use, make sure power is off before pulling
out the plug and do not pull the cord.
13. When the appliance is not in use for a prolonged period, please turn it off, unplug it and pack it
well. Then store it in dry cool place.
14. Forbid to put flammable and explosive objects around the appliance, and do not use the
appliance in an environment full of flammable gas and powder. Keep away from any fire and
heat sources.
15. Please put the power cord in the right place in order to avoid tripping the appliance over.
16. Please keep the air inlet and outlet unblocked to minimize the risk of fire and malfunction.
17. Ensure no water or raindrop into the appliance in order to avoid electric shock. Do not put
flammable objects or wet clothes on the air outlet in order to avoid short circuit or fire.
18. Please do not place air inlet or outlet near to curtain or wall when operation because it will
block air current and cause a risk of fire. The appliance should be installed at minimum distant
of 10 cm from the wall or other obstacle.
19. Please do not insert any objects into air inlet and outlet in order to avoid electric shock.
20. After a period of operation, there may be abnormal noise and uneven air volume because of
dust blocking airflow. It will disappear after cleaning the air inlet and outlet
21. Do not insert any objects in the grille to prevent any injury or damage.
22. Do not hang any objects on the grille to prevent destabilizing the fan and impairing its
operation.
-3-
-2-

PARTS DESCRIPTION
INSTALLATION INSTRUCTION
Caution: Please unplug the appliance before installation.
1. Base and motor installation
‧ Loosen the height adjustment ring, then put the base cover on the outer pole (Fig. 1).
‧ Lift the inner pole to certain height and screw the height adjustment ring in clockwise
direction (Fig. 2).
‧ Fit the outer pole into the centre section of the base plate (Fig. 3).
‧ Fasten the base knob at the bottom of the base plate to fix the position of the outer
pole with the base plate (Fig 4).
‧ Loosen the screw on the bottom of the head unit but do not unscrew it totally
(Fig. 5).
‧ Place the head unit on the inner pole and tighten the screw (Fig. 6).
Fig.1 Fig.2 Fig.3
Fig.4 Fig.5 Fig.6
2. Grille and fan blades installation
A. Rear grille
‧ Unscrew the fan blade knob from the motor shaft in clockwise direction (Fig. 7).
‧ Unscrew the grille knob from the motor shaft in anti-clockwise direction (Fig. 8).
‧ Set the rear grille and fit it well on the three position poles and make sure these poles
are properly put through the holes on the rear grille. Hold the rear grille and tighten
the grille knob in clockwise direction on the motor shaft (Fig. 9) .
Fig.7 Fig.8 Fig.9
B. Fan blade
‧ Install the fan blade through the fan blade position hole. Ensure the fan blade grooves
fit the motor shaft fixing pin and push in until it reaches the fixing pin (Fig 10).
1.Front grille
2.Fan blade
3.Grille ring
4.Height adjustment pole (inner)
5.Height adjustment ring
6.Height adjustment pole (outer)
7.Base cover
8.Base plate
9.Power cord
10.Motor
11.Oscillation Knob
Height
adjustment
ring
Base
cover
Twist in
clockwise
direction
Bottom part of
the outer pole
Centre
section
on the base
plate
Base
knob Screw
Screw
Insert
position
poles
grille knob
-4- -5-

‧ Install the fan blade knob in anti-clockwise direction onto the motor shaft until it is
tightened. Please hold the fan blade when installing the fan blade knob (Fig. 11).
Fig.10 Fig.11
C. Front Grille
‧ Normally, the grille ring is installed with the front grille. Loosen the screw on the
bottom of the grille and fit the front grille with grille ring into the rear grille. After
that, lock the guard clip and tighten the screw (Fig.12).
Fig.12
OPERATION INSTRUCTION
1. Power on / speed adjustment
‧ Press fan speed button for speed adjustment：
0:Off / Stop 1:Low Speed 2:Medium Speed 3:High Speed
2. Oscillation
‧ Press down the oscillation knob, the fan is operated in
oscillating mode to swing horizontally. Lift the knob,
oscillation will be stopped.
3. Height adjustment
‧ Hold the height adjustment pole and loosen the height
adjustment ring, then adjust the pole to the required height and
tighten the height adjustment ring by twisting it in clockwise
direction.
4. Angle adjustment
‧ Turn off the fan, then lift or press the motor lightly to adjust the
blowing angle.
MAINTENANCE INSTRUCTION
Caution:
‧ Please turn off and unplug the appliance before cleaning or maintenance.
‧ Clean the surface of the appliance with damp cloth (or add some detergent) and wipe by
dry cloth.
‧ Make sure the appliance is dry before use it again.
‧ Do not use corrosive detergent or solvent to clean the appliance to avoid any
discolouration or damage.
‧ Do not swash with water.
‧ Do not use hard objects to clean the fan.
‧ Regular cleaning is suggested to avoid dirt blockage that may result in mechanical
failure.
SPECIFICATION
Model No. KSF1613
Product name Stand fan
Voltage/Frequency 220V/50Hz
Power 55W
Dimension (W x H x D) 450 x1250x400mm
Grille cli
p
Motor shaft
fixing pin Motor
shaf
t
Fan blade
position hole
fan
blade
groove
Oscillation
Knob
Twist in
clockwise
direction
-6- -7-

WARRANTY
1. The product has 1 year warranty from the date of purchase.
2. The warranty shall not apply:
A. to any Product subjected to accident, misuse, neglect, alteration, Acts of- God,
improper handling, improper transport, improper use, improper testing or
unauthorized repair;
B. to cosmetic problems or defects which result from normal wear and tear under
ordinary use, and do not affect the performance or use of the product. All
warranties are void if the product is opened, altered, and/or damaged;
C. to any packing, transportation, export / import tax or any related expenses.
3. CUSTOMER MUST PRESENT THE SALES INVOICE OR RECEIPT FOR 1
YEAR WARRANTY SERVICES.
4. Please bring along the product and sales invoice or receipt to our services center for
warranty services during office hour:
Address : UnitA, 20/F, Yip Shing Industrial Centre, No.19,
Yip Shing Street, Kwai Chung.
Service Hotline : [phone]
Service Hours:
Monday-Friday : 9:00am - 6:00pm
Saturday : 9:00am - 4:00pm
Sunday & Public Holiday : Closed
5. To prevent circuit overload and fire, no more than one adaptor or one extension unit
should be inserted into a socket outlet. (Do not connect other appliances to the socket
outlet supplying an electric heater.) No adaptor should be inserted into any extension
unit or vice versa.
6. Stop using an adaptor or extension unit or socket if its socket holes cannot firmly hold a
plug or if it is too hard to insert a plug into it.
7. Please make sure the plug is fully plugged-in before use. Do not use any adapter or
extension cord; Never use the same supply socket for this appliance and other
appliances at the same time, in order to avoid damage to this appliance.
8. THE APPLIANCE IS FOR HOUSEHOLD USE ONLY.
IMPORTANT NOTICES
IN NO EVENT SHALL OUR COMPANY OR THE SUPPLIER BE LIABLE TO YOU OR
ANY OTHER PARTY FOR ANY DIRECT, INDIRECT, GENERAL SPECIAL,
INCIDENTAL, CONSEQUENTIAL, EXEMPLARY OR OTHER DAMAGES ARISING
OUT OF THE USE OR INABILITY TO USE THE PRODUCT (INCLUDING, WITHOUT
LIMITATION, DAMAGES FOR INJURY, LOSS OF PROPERTY, BUSINESS PROFITS,
BUSINESS INTERRUPTION) OR FROMANY BREACH OF WARRANTY, EVEN IF
OUR COMPANY OR SUPPLIER HAS BEEN ADVISED OF THE POSSIBILITY OF
SUCH DAMAGES. IN NO CASE SHALL OUR COMPANY OR SUPPLIER'S
LIABILITY EXCEED THE AMOUNT YOU PAID FOR THE PRODUCT.
Specifications, designs and dimensions subject to change without prior notice.
-8- -9-