KEMET USEQCSK0000000 User manual

USEQCSK0000000 – QUICK START GUIDE – Please Refer to the Sensor Evaluation Tool Software User Manual
© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com 1
1. Check the Contents
3. Populate the Backplane Board with up to 4 Sensors (Sensors not Supplied with the Backplane Board)
A. Preassembled backplane PCB (green) with
STM32nucleo board (white)
B. USB stick (evaluation software)
C. Ribbon cable, optional use (up to 4)
D. USB communications cable
2. Install Software
Install Sensor Evaluation Tool from the folder
on the USB stick. Software is compatible with
Windows 7, 8, 10.
Connect sensor to the Sensor 1
position. You can connect the sensor
directly to the socket on the board or
use one of the supplied extension
ribbon cables.
Add further sensors in numerical
order. For example, if you want to use
two sensors ensure they are placed in
positions 1 and 2.
NOTE: One sensor must be connected
to the Sensor 1 position for the system
to work correctly.
2 sensors 3 sensors 4 sensors
A
B
C
D

USEQCSK0000000 – QUICK START GUIDE – Please Refer to the Sensor Evaluation Tool Software User Manual
© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com 2
4. Connect Backplane Board to Computer
5. Check LEDs
Insert the USB cable into a suitable port on your PC, and connect the
other end into the STM32nucleo board.
Check that the following LEDs are illuminated.
On the STM32nucleo card:
•LD1 (red) next to USB socket
•LD2 (red) next to Reset button
•LD3 (green) next to Reset button
On the sensor side of the backplane board:
•Running LED (red - flashing)
•Ready LED (green - only lit when sensor(s)
connected)
•Power LED (amber)
If this is not the case, check that the STM32nucleo
board and sensors are correctly seated and that the
USB cable is connected to a powered socket.
6. Run Sensor Evaluation Tool
8. Check Sensor Operation
Open the Sensor Evaluation
Tool from the KEMET folder in
the Start menu of the
connected computer.
7. Select Device
Select COMxx : Sensor firmware vX.xx from the dropdown list (where
x = comport number and the firmware version number, these values
may change).
If no device is shown, check all connections and then select Rescan
Ports.
~30 cm
If a sensor is unresponsive, unplug it from the backplane board and then
reattach, double-checking pin alignment and orientation. Restart the
Sensor Evaluation Tool. For more details see the full Sensor Evaluation
Tool Software User Manual.
Move your hand across
the sensors and observe
deflections in the traces
on the screen.