KEMMLIT SKIRMETT Hive Lock User manual

Hive Lock

Hive Lock
Product Overview

Technical Drawing
Hive Lock

Hive Lock
RFID Cards

Management Card
Hive Lock
Functions:
oAuthorise and Delete Master cards.
oAllow read lock status and events.

Master Card
Hive Lock
Functions:
oInspection opening mode
oDelete User cards.
oReset User cards ( back to blank function ).

Multi-User Card
Hive Lock
Functions:
Open / Close Locker

Hive Lock
Operating Instructions

Master Card - Operating Instructions
Hive Lock
Inspection Mode
Step 1
Present the Master card (ONLY ONCE) to the lock and wait 5 seconds.
After a long beep the lock will open automatically for 30 seconds.
After 30 seconds the lock will return to the close positon.
NB
The User Card is not deleted during this Inspection Mode

Master Card - Operating Instructions
Hive Lock
Delete User Card
Step 1
Present the Master card four times to the lock and wait 5 seconds.
You will hear four short beeps and the User Card will be deleted.
At the same time the lock will automatically open.
The lock is back in the reset mode, ready for a New User.

Master Card - Operating Instructions
The Hive
Reset User Card
Step 1
Present the Master card five times to the lock and
then present the User Card.
You will hear five short beeps as you present the
User Card.
The User Card will be reset.

User Card - Operating Instructions
Hive Lock
The Locker is not occupied and the
shoot bolt is inside the lock.
Step 1
Present the User Card to the Lock
User Card
OK - Long Beep
Not OK –3 Beeps

User Card - Operating Instructions
Hive Lock
The shoot bolt will extend out, moving to
the locked position.
Step 3
The Lock is ready to close and secure the locker shut
Step 4
You can now close the locker door
Please Note:
The Hive and User card are now linked
The User card will not open or close another lock whilst it is linked to this Hive

Hive Lock
Battery Information

Battery Replacement
Hive Lock
Batteries replacement
Torx T20
To release the battery holder turn the T20 screw.
PRESS the screw’s head till the battery holder rises out.
Once the batteries have been replaced, push the battery holder
back into position and tighten the screw.
2 x CR123A

Battery Level Warning
Hive Lock
beep
beep
beep
The lock emits beeps repeatedly and does not close.
The battery level is very low and needs to
Be replaced before it will function correctly.
Please replace the battery.

Thank you for your attention