Kenroy Home 60506 User manual

MODEL: 60506
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
READ INSTRUCTIONS ALL THE WAY THROUGH
PRIOR TO ASSEMBLY.
Assembly Time: 20 Minutes.
UNPACK THE SOLAR LED LIGHT STRING
The following parts should be included in your
solar light kits; (10) Solar LED Lights, (1) Solar
panel, (1) Stake, (1) Countersink Spade Bit.
TOOLS
A drill will be required for deck or hard surface
installation.
3.) Slide the LED light body through the
bottom of your deck.
4.) Once through the hole, screw the lens to the
body.
5.) Drop in place.
DECK INSTALLATION
GROUND INSTALLATION
Bury the Solar LED Light String bodies in grass,
mulch, or gravel. You may wish to create a small
trench between lights in order to conceal the
cable.
TIP:
Use your drill and the included spade bit for
greater precision.
1.) Using your drill with the included spade bit,
carefully drill through your deck, keep drilling
until the flag touches the deck's surface.
2.) Remove the lens from the body.

PANEL ASSEMBLY AND INSTALLATION
4.) Once charged for 6~8 hours, your LED Light
String is ready for use. Slide the switch on the
back of the solar panel to turn the lights on.
MODEL: 60506
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
1.) Push stake into tube as shown below.
Note: You can adjust the angle of the solar panel.
3.) Insert the stake of solar panel into the ground
in a sunny area.
2.) Join the connectors and screw the cap tightly
together.
5.) The Solar LED Light String will turn on
automatically at dusk, lasts 9~10 hours after full
charge.
6.) The Solar LED Light String accepts panel
extention accessory 60509 (12' length extender
cord) (sold separated).

MODEL: 60506
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
TROUBLE SHOOTING:
1.) If your Solar LED Light is not functioning properly or losing power mid-cycle, then ensure
the solar panel is positioned in direct sunlight. Your solar panel will need to collect between 6 ~ 8
hours of sunlight to function throughout a full cycle.
2.) Check your connections to the solar panel - a loose or improperly connected cable will cause
the LED Light String to malfunction.
3.) Although the battery inside your Seriously Solar panel is designed for maximum longevity,
overtime performance will drop - replacing the battery will correct this issue.
IMPORTANT NOTES:
1.) The led light will turn on automatically every night.
2.) Although there may be some initial charge in battery, we recommend fully charging it before
first use. turn off the led light and leave the solar panel in good sunlight for 6 hours to ensure the
battery is fully charged.
3.) To maximize solar energy intake, the solar panel may be cleaned periodically with a soft rag
and water, do not use chemical solvents.