Kensington Locking Kit for Mac Studio User manual

Locking Kit for Mac Studio

1. Rotate the two parts of the locking plate adapter so that they are perpendicular to each other. Locate the pin on the locking plate and insert it into the
connection point on the underside of the Mac Studio.
2. Rotate the lower part of the locking plate 90 degrees so that it is directly under the upper part of the locking plate.
3. The locking plate should now look like one one piece, with the lock slot visible.
Attaching the lock.
Connecting a locking cable (sold separately).
4. Attach the cable lock to a fixed point, such as a desk.
5. Depress the button on the lock head and hold it down.

Disconnecting a locking cable (sold separately).
1. Locate the notches next to the combination wheel. Rotate the numbers to the correct combination, so that they align with the notches.
2. Depress the button on the lock head and hold it down.
3. Pull the lock away from the adapter. It is now disconnected.
6. While the lock head button is depressed, insert the lock head into the slot on the locking plate adapter.
7. Release the button on the lock head and scramble the numbers on the combination.
8. Your Mac Studio is now locked.

Setting the combination lock code.
1. On one side of the lock head, locate the notches next to the combination wheel. Rotate all of the numbers to zero (default combination), so that the zeros are aligned
with the notches.
2. Insert an unbent end of a paper clip into the slot on the end of the lock head.
3. Depress the paper clip into the lock head as far as it will go.
4. Rotate the paper clip clockwise 90 degrees.

5. With the paper clip rotated 90 degrees, set the numbers to the desired combination, ensuring that the desired numbers are aligned with the notches.
6. Once the combination is set, rotate the paper clip counterclockwise 90 degrees and remove. Your lock is now ready for use.

For support, visit kensington.com/support.