• Turning the screw of the valve
anti-clockwise, results in increased mineral
content.
• Turning the screw of the valve clockwise,
results in decreased mineral content.
• Switch on the power supply .
• Allow the storage tank to fill to its
maximum capacity.**
• Switch off the power supply.
• Open the drain plug present at the bottom
of the storage tank and drain the tank
completely. This would remove the
residual dust particles present in different
pipes and storage tank.
• Plug back the drain plug.
• Switch on the power supply.
• The purifier is now ready to use.
• The storage tank must be drained once in 2
weeks. Open the drain plug present at the
bottom of the storage tank and drain the
tank completely. Plug back the drain plug
and switch on the power supply.
• Replace the sediment filter & activated
carbon filter once in 12 months. It is
recommended to change the FRT along
with the filters.
• Replace the RO membrane once in a year.
• Replace the UF membrane once in a year.
• In the event of not using purifier for a long
time (while going for a holiday, tour etc.),
make sure that you disconnect the power
supply, turn off the raw water supply and
drain the storage tank.
The unique TDS Control System enables customers to retain the contents of natural minerals
(TDS) in the purified water, as per their requirement.
Although the rejected water has high concentration of salts, it is absolutely clean and free from
impurities such as chlorine, dirt, sand, etc. This rejected water usually goes down the drain but
can be used for gardening purposes. The high concentration of salts and minerals accelerates
the plant growth. Rejected water can also be used for cleaning utensils, mopping etc.
“This reverse osmosis system contains a replaceable component critical to the efficiency of the
system. Replacement of the reverse osmosis component should be with one of identical
specifications as defined by the manufacturer, to ensure the same efficiency and contaminant
reduction performance.”
Note: The reverse osmosis system contains a replaceable treatment component critical for the
effective reduction of total dissolved solids and that product water shall be tested periodically
to verify that the system is performing properly.
To ensure that the purifier operates at its BEST, routine maintenance must be performed.
Frequency of the maintenance will greatly depend upon the raw water quality and consumption
of purified water.
Important Safety Instructions
• If the supply cord is damaged, it must be replaced by the original part in order to avoid hazard.
• Children should be supervised to ensure that they do not play with the appliance
• This appliance is not intended for use by persons (including children) with reduced
physicasensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person responsible
for their safety
Replacement of spare parts are as under:-
-20010 SP Inline Sediment Filter 8”
-20009 SP Inline Carbon Filter 8”
-20890 SP RO Membrane
-20004 SP UF Membrane Welded 8” Housing
-20020 SP FRT 300/450
TDS Adjustment*
Starting Up the Purifier
Recommended Usage of Rejected Water
Maintenacec
The replacement time of consumables such as filters and membrane is dependant
on the quality of raw water and the quantity of purified water consumed.
Use genuine Kent spares for optimum performance.
