KETCHAM AURORA Series User manual

IMPORTANT SAFETY INSTRUCTIONS
AURORA SERIES, AURORA+ SERIES
LUMINOUS SERIES, LUMINOUS+ SERIES
RADIANT SERIES, RADIANT+ SERIES
STELLAR SERIES, STELLAR+ SERIES
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
When using an electrical product, basic precautions should
always be folllowed, including the following:
!
!
!
!
WARNING
WARNING
WARNING
WARNING
To reduce the risk of burns, fire, electric shock, injury or death,
use this product only for its intended use as described in these
instructions. Do not use attachments not recommended by the
manufacturer. Never drop or insert any object into any opening.
Do not use outdoors.
Installation should be done by a licensed professional.
Failure to follow proper installation will void warranty.
Risk of electric shock. Connect this product to a properly
grounded circuit only. See grounding instructions below.
An electrical option mirror must be wired to a 20 Amp GFI
(Ground Fault Interrupter) protected circuit when used in
bathrooms and all other locations required by the
National Electric Code.
Grounding Instructions:
This product must be connected to a grounded metal,
permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead
on the product.
LED MIRROR
INSTALLATION GUIDE

A
B
111/2”
13/4”
X
Y
51/4”
20”x 30” 24”x 36” 30”x 36” 48”x 36” 60”x 36”
A20” 24” 30” 48” 60”
B30” 36” 36” 36” 36”
X13 1/2” 17 1/2” 23 1/2” 41 1/2” 53 1/2”
Y23 3/4” 29 3/4” 29 3/4” 29 3/4” 29 3/4”
A- Mirror’s Width |B- Mirror’s Height
X- Distance Between Vertical Mounting Holes |
Y- Distance Between Horizontal Mounting Holes
SIZE GUIDE:
<Depth>
<W>
<H>

Ground
A
B
Wiring from light fitting
Natural wire White(N)
Green/yellow
Live Wire
Ground(green/yellow)
Black(L)
1
DETAIL 1
1. GAP 0.2”
WALL
1
DETAIL 1

FINAL ASSEMBLY
Use and Maintenance:
CLEANING A STANDARD MIRROR SURFACE:
-Mirror and mirror body are constructed of mirrored glass and aluminum. Use a damp cloth
to clean your mirror. Do not use any abrasive material as it may damage the surface and
finish of the mirror.
-A mild detergent may be used to clean the surfaces of the mirror.
-When cleaning, spray the cloth, not the mirror or surrounding surfaces.
How to use Defogger Feature and Dimmer Switch:
** if applicable
Adjusting Kelvin Temperature:
To change the Kelvin temperature, simply double tap the sensor.
Kelvin temperature options are: 3000K, 4500K, and 6000K.
Adjusting the Brightness:
To adjust the brightness, hold down the sensor and it will begin to fade down. To increase the brightness,
tap and hold the sensor again.
Operating the Defogger:
To turn on the defogger, tap the sensor. When you hear a click, the defogger is now turned on. The
defogger will take approximately 5 minutes to heat up. To turn off the defogger, tap the touch sensor again, and
you will hear defogger unit click off.